User manual KENWOOD DP-R3080

[. . . ] AC 230 V only China . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 110-120 / 220-240 V switchable *AC voltage selection The AC voltage selector switch on the rear panel is set to the voltage that prevails in the area to which the unit is shipped. Before connecting the power cord to your AC outlet, make sure that the setting position of this switch matches your line voltage. If not, it must be set to your voltage in accordance with the following direction. AC voltage selector switch AC110-220V 2 3AC220-240V AC110-220V 2 3AC220-240V OUTPUT DIGITAL OUTPUT OPTICAL COAXIAL L SYSTEM CONTROL LINE 1 L LINE 2 SL16 XS 8 R R Note: Our warranty does not cover damage caused by excessive line voltage due to improper setting of the AC voltage selector switch. Move switch lever to match your line voltage with a small screwdriver or other pointed tool. For the United Kingdom Factory fitted moulded mains plug 1. [. . . ] When the power is turned ON, press the key of the function to be operated. 30 30 Remote control light sensor 6m ÷ When pressing more than one remote control key successively, press the keys securely by leaving an interval of 1 second or more between keys. Operating range (Approx. ) REMOTE CONTROL UNIT RC-P0505 Notes 1. When the remote-controllable distance gets shorter than before, replace both batteries with new ones. Malfunction may occur if direct sunlight or the light of a high-frequency lighting fluorescent lamp enters the remote control light sensor. In such a case, change the system installation position to prevent the malfunction. Normal play (TRACK mode) DP-5090/4090 (En) 10 Use the following procedure to play a CD in the original order of tracks from track No. 1. COMPACT DISC PLAYER DP-5090 REMOTE CONTROL UNIT RC-P0505 : Keys and control used in the operations described on this page. Playing tracks in order from track No. 1 1 Press the POWER switch to ON. POWER -ON ­OFF ÷ Playback starts when a disc has been loaded. 2 Load a disc. 1 Open the door. 0 2 Place a disc. Label side Disc tray ÷ Do not touch the played side of disc. (If the disc is not placed horizontally, malfunction will result. ) ÷ A single CD (8 cm disc) can also be played. ÷ Ordinary CD single (8 cm) disc adapters sold in audio stores cannot be used with this unit. 3 Close the door. 0 CLOSE · ÷ In the case of a CD-TEXT disc, the disc's title is scrolled on the display. 3 Start playback. 6 Lights up. 01 Track NO. being played 1:23 Elapsed time of track being played ÷ In the case of a CD-TEXT disc, the track's title is scrolled on the display. What is then displayed is in accordance with the TEXT DISPLAY mode. # To pause playback 6 To stop playback 01 Lights up. 7 ÷ Each press pauses and plays the CD alternately. DP-5090/4090 (En) 11 COMPACT DISC PLAYER DP-5090 REMOTE CONTROL UNIT RC-P0505 : Keys and control used in the operations described on this page. Playback from desired track Remote control unit only Select the desired track No. 1 2 3 Press the numeric keys as shown below. . . . 40 : 003 0000) 4 5 6 7 REMOTE CONTROL UNIT 8 9 RC-P0505 0 +10 ÷ Playback starts from the selected track and continues on the subsequent tracks. Skipping tracks To skip backward 4 ¢ To skip forward ÷ The track in the direction of the pressed key is skipped, and the selected track will be played from the beginning. ÷ In the case of a non-CD-TEXT disc, the "NO CD TEXT" display will appear for approx. 3 seconds. Programmed play (PGM mode) DP-5090/4090 (En) 14 Use the following procedure to program desired tracks in a desired order. (up to 32 tracks) Preparation ÷ Load a disc in the CD player. COMPACT DISC PLAYER DP-5090 REMOTE CONTROL UNIT RC-P0505 : Keys and control used in the operations described on this page. 1 Press so that the "PGM" indicator lights. Do this operation in the stop mode. P. MODE REMOTE CONTROL UNIT Blinks. PGM01 TNO. ?? RC-P0505 2 Program desired tracks. 1 Select the desired track No. Press the numeric keys as shown below. . . . 2 5 AB « PGM01 ABCDEFGH REMOTE CONTROL UNIT 4 5 RC-P0505 6 7 8 9 In the case of a CD-TEXT disc, the track's title is scrolled on the display. 0 +10 PGM01 TNO. 25 Go to step 2 within 8 seconds. 2 Set the entry. P. MODE REMOTE CONTROL UNIT RC-P0505 3 Repeat steps 1 and 2 above. ÷ Tracks can also be selected by pressing the 4 or ¢ key. ÷ If you make a mistake, press the CLEAR key and enter the track No. ÷ When the total playing time of the programmed tracks exceeds 100 minutes, the remaining time on the disc will not be displayed any more. 3Start playback. 6 REMOTE CONTROL UNIT RC-P0505 ÷ When the 4 or ¢ key is pressed during playback, the track will be skipped in the direction of the pressed button. ÷ When the 4 key is pressed once during playback, the play position returns to the beginning of the current track being played. To stop playback 7 ÷ The programmed contents remain in memory. REMOTE CONTROL UNIT RC-P0505 DP-5090/4090 (En) Auto space function During programming of tracks, a non-recorded space of a few seconds will be automatically created between tracks. By recording tracks with these spaces on tape, the search and repeat play operations of tape using the DPSS function (which works by searching the non-recorded spaces) can be performed reliably. ÷ Even when the performances of two tracks are continuous (which occurs with classical or live recording music), the spaces will be created if they have different track Nos. 15 To check or change the programmed tracks 1 Press the CHECK key. CHECK Remote control unit only Blinks. Press until the track No. to be changed is displayed. PGM01 TNO. 25 ÷ Perform only step 1 to simply check the program. ÷ In the case of a CD-TEXT disc, the track's title is scrolled on the display. [. . . ] 32 fs (1411 kHz) [ Audio ] Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Hz ~ 20 kHz, ±0. 5 dB Signal to noise ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . More than 114 dB Dynamic range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . More than 100 dB Total harmonic distortion + noise . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]