User manual KOMPERNASS KH 3256 WORKSHOP TOOL TROLLEY

[. . . ] J Always use axle stands and wheel chocks in addition to your hydraulic vehicle jack. Never work under a raised vehicle unless you have taken additional safety precautions. This is intended to prevent the vehicle from rolling away, sliding off or overturning the jack. [. . . ] This is intended to prevent the vehicle from rolling away, sliding off or overturning the jack. Using the product on an unstable or uneven surface ­ such as a gravel surface ­ may lead to the load slipping. The person operating the jack must observe the jack and the load during all movements. Never work under the raised load if it has not been made secure by suitable means. Do not allow the hydraulic vehicle jack to be used by uninstructed or inexperienced persons. Before using the hydraulic vehicle jack take precautions to prevent the vehicle from rolling away. put the handbrake on , place the vehicle in gear (with automatic gearboxes set to "P") and chock the wheels. Follow these steps: j irst raise the vehicle slightly in order to be able to remove the F axle stands. J lace a tube section with locating slot 6 on to the release valve 5 . A) until the vehicle moves downwards but not enough that hydraulic oil escapes from the release valve 5 . Lower the vehicle slowly otherwise there is the danger C of injury and damage to the product or to the vehicle. Follow these steps: j lace one of the tube sections with a locating slot 6 on to the P release valve 5 and turn it in the direction (see Fig. j lace the hydraulic vehicle jack under one of the lifting positions as P shown in the owner's manual supplied by the vehicle manufacturer. J crew out the extension screw 2 in the S direction until the saddle comes into contact with the underside of the vehicle. [. . . ] Follow these steps: j lace one of the tube sections with a locating slot 6 on to the P release valve 5 and turn it in the direction (see Fig. j lace the hydraulic vehicle jack under one of the lifting positions as P shown in the owner's manual supplied by the vehicle manufacturer. J crew out the extension screw 2 in the S direction until the saddle comes into contact with the underside of the vehicle. [. . . ]