User manual KOMPERNASS PARKSIDE PDS 200 A KH 3167 BENCH GRINDER

[. . . ] Avoid touching earthed objects such as pipes, heating radiators, ovens or refrigerators with parts of your body. Do not allow other people, in particular children, to touch the electrical power tool or the mains lead. When not being used electrical power tools should be stored in dry conditions in a high or enclosed place, out of reach of children. By keeping within the specified working range of the tool you will work more safely and achieve a better result. [. . . ] Have your electrical power tool repaired at an electrical equipment repair specialist. ½ This electrical power tool complies with the relevant safety regulations. Repairs may only be carried out by a specialist electrical repair centre using original spare parts, otherwise injury could occur to the user. ½ Do not touch the mains lead if it becomes damaged Or cut through while you are using the device. Pull the plug out of the mains socket immediately and have the device repaired by a suitably qualified person or at your service centre. ½ Do not operate the device if it is damp and do not use it in a damp environment. ½ If you use the device outdoors, always connect it through a residual current device (RCD) with a maximum trip current of 30 mA. General safety advice / Before use If using an extension lead, always use one that is approved for outdoor use. If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Always work with the mains lead leading away from the rear of the device. For this reason, always make sure that nobody is placed in any danger and that there are no inflammable materials near the working area. Working with harmful / noxious dusts represents a risk to the health of the person operating the device and to anyone near the work area. Wear protective glasses, hearing protection, dust protection mask and protective gloves. When grinding for longer periods, stop grinding from time to time and allow the workpiece to cool before continuing. Only use grinding wheels with details that correspond with those given on the device rating plate. The circumferential speed should be equal to or greater than the value given on the device rating plate. Adjust the eye guard mounts 2 (spark deflectors) and the eye guards 3 periodically so that wear on the grinding wheels can be evened out. Before you insert the mains plug into the socket, always check that the device is switched off. After grinding, lift off the workpiece before switching the device off. After you have finished grinding metal, allow the grinding wheel(s) to come to a standstill. When taking a break from your work, before carrying out any tasks on the device itself and when you are not using the device, always pull the mains plug out of the mains socket. Do not use the device if you cannot concentrate or you are feeling unwell. [. . . ] If you install new grinding wheels carry out a ringing test before use. Grinding wheels in good condition give a clear ringing noise when struck lightly with a plastic hammer. 1) Take off the outer part of the wheel guard cover 7 by unscrewing the 3 threaded fixings (see Figs. Preparing for first use Switching on and off Switching on: Press the ON / OFF switch 9 into the "1" position to switch the device on and run it at a constant speed. [. . . ]