User manual KONICA MINOLTA FK-502

[. . . ] User's Guide [FK-502 Fax Operations] Contents Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . x-15 ACKNOWLEDGEMENT: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . x-15 COPYRIGHT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . x-15 EXEMPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The scanned original is stored in the memory as a scheduled job and transmission is started. C451 6-32 Useful transmission functions 6 6. 9 Sending an original of varying sizes by a single operation (Mixed Original) Mixed Original Mixed Original is a function that detects each original size when an original with varying sizes is loaded. Transmitted and reproduced in the same sizes as the original pages at the destination You set original pages of mixed sizes on the ADF 2 Note When Scan Size setting and Mixed Original setting are specified at the same time, the size specified in Scan Size setting is applied. Quick Memory TX, Total # of Pages, Z-Folded Original, Long Original, Binding Position, Polling RX, Bulletin board Polling RX Sending the fax after specifying Mixed Original setting 1 2 Press [Fax/Scan] key to display the Fax/Scan screen. ­ ­ The possible combinations of original sizes differ depending on the widest original loaded (position of the lateral guides). For details on the mixed original sizes that can be loaded in the ADF, refer to the User's Guide [Copy Operations]. C451 6-33 Useful transmission functions 6 3 Arrange the sending side of the original upwards as shown in the figure. 4 Arrange the sending side of the original upwards and load it in the paper feed tray. ­ Load the original pages into the ADF so that the top of the pages is toward the back or the left side of the machine. Lateral guide 5 6 Touch [Original Settings]. Touch [Mixed Original]. C451 6-34 Useful transmission functions ­ Touch [Mixed Original] again to cancel the settings. 6 7 8 Touch [OK]. ­ ­ ­ For details on Scan Settings, refer to "Specifying scanning conditions" on page 2-12 or "Scan Settings" on page 6-2. For details on Original Settings, refer to "Original Settings" on page 6-4. For details on Communication Settings, refer to "Communication Settings" on page 6-5. 9 Specify the destination. ­ For details on destination, refer to "Specifying only one destination" on page 2-17 and "Specifying multiple destinations (Sequential broadcast transmission or broadcast transmission)" on page 2-31. 10 Press [Start] key. ­ If the fax cannot be sent because the recipient's line is busy, the recipients number is redialed. For details on redial, refer to "When unable to send fax" on page 2-42. ­ To stop the transmission, refer to "Aborting transmission" on page 2-49. ­ If the fax could not be sent, refer to "Fax cannot be sent" on page 4-2. The scanned original is stored in the memory as a scheduled job and transmission is started. C451 6-35 Useful transmission functions 6 6. 10 Sending an original with folds (Z-Folded Original) Z-Folded Original Function to fax originals with original sizes that cannot be correctly detected due to fold lines. 2 Note Use ADF. Originals from the second original onwards are transmitted with the size same as that of first original. When the original size differs for each page, specify [Mixed Original] without specifying Z-Folded Original. Mixed Original, Long Original, Polling RX, Bulletin board Polling RX, and Separate Scan settings C451 6-36 Useful transmission functions Sending the fax after specifying Z-Folded Original setting 6 1 2 Press [Fax/Scan] key to display the Fax/Scan screen. ­ For details on loading originals, refer to "Loading the original" on page 2-7. 3 4 Touch [Original Settings]. ­ Touch [Z-Folded Original] again to cancel the settings. 5 6 Touch [OK]. ­ ­ ­ For details on Scan Settings, refer to "Specifying scanning conditions" on page 2-12 or "Scan Settings" on page 6-2. For details on Original Settings, refer to "Original Settings" on page 6-4. [. . . ] If memory transmission is used, the total number of pages are automatically printed in the page number of the transmission source information and an image of the first page of the sent original is printed in the transmission report. However, the memory may become full if there are many pages of the original or if the data is large due to finely detailed images. The operation of optically scanning the original and converting it to image data. This is a function to specify the scanning size of an original and transmitting it. [. . . ]