User manual KONICA MINOLTA PS3000 OM

[. . . ] Operator's Manual PS3000 Operator's Manual INTRODUCTION Thank you for choosing the Minolta DPCS3000 (PS3000 + Di30). This users manual explains the various functions provided by the DPCS3000. Before operating this system, read this manual carefully until you familiarize yourself thoroughly with its operation and features. -Always refer to this manual when operating the system and do not attempt to touch the system parts for which no explanations are given in the text. [. . . ] Left Start Key Right Start Key Page-by-Page: Each of the verso (left) and recto (right) pages of the open book is copied onto a separate single sheet of paper (verso only or recto only). Check that the Display Panel tells that the system is ready to make copies. (See Placing the Original on p. 3-7 and Notes on Originals on p. 3-5. ) 3. Adjust the height of the right- and lefthand sides of the Original Table so that the top surfaces of the two pages of the original level off, as visually checked. 3-10 PC3000 Operator's Manual Chapter 3 4. Example 1: To make a page-by-page copy of the recto (right) page of an open book or a sheet original, check that the message and lit Start Key are as shown in A at left and then press the right Start Key. Example 2: To make a spread copy on a single sheet of paper of the recto (right) and verso (left) pages of an open book or a sheet original, check that the message and lit Start Key are as shown in B at left and then press either the right or left Start Key. 5. The lamp lights up with full intensity and the Scanner starts reading the data on the original. At this time, the Display Panel shows the message, the Start Key or Keys light up orange, and the Original Table is locked. 6. The lamp then lights up with half intensity and the Start Key or Keys turns green. At this time, the Original Table is unlocked. NOTE If Warn of Set is set, a buzzer sounds and a warning is given on the Display Panel if the Scanner is unable to read the data correctly when the Start Key is pressed. The reading sequence is interrupted at this time. 3-11 PS3000 Operators Manual Chapter 3 Types of Copy The system allows you to make three different types of copy. Spread Copy The system copies the image of the original symmetrical around the center of the Original Table onto a single sheet of copy paper. When the key is pressed, its LED lights up green. 1 2 1 2 Page-by-Page Copy The system copies each page of the original determined with reference to the center of the Original Table onto a single separate sheet of paper. When this key is pressed, its LED indicating the page to be copied lights up green. 1 PushLeft Start Key 2 PushRight Start Key 1 2 Book Split Copy 1 PushLeft Start Key 2 PushRight Start Key 1 2 1 The system copies each page of the original determined with reference to the center of the Original Table onto a single separate sheet of paper, consecutively from the verso to recto page, or vice versa. The page for which the Start Key is pressed becomes the first copy, the opposite page the second copy. This function is valid under: Book Orig: ON Book Split: ON Page-by-Page Key: ON 2 3-12 PS3000 Operator's Manual Chapter 3 Book Original Mode (Book Orig) Select this mode when making copies of a book original using PS-3000. Functions Automatically Set Curved Text Line Correction This function is automatically enabled when Book Orig is selected. It matches the positions of the texts on the curved lines near the central parts between the pages of an open thick book with those of other texts, ensuring that a undistorted copy will be made. Text Compression Correction This function is automatically enabled when Book Orig is selected. The texts near the central parts between two pages of an open book look crowded with little spaces between characters when viewed from the top, since those parts of the pages are curved. If they are copied as they are, the result is a text squeezed sideways. This function expands the characters according to how they are squeezed, providing a copy as close as possible the original form. [. . . ] Error Message If an error occurs in PS3000, an error message appears on the Display Panel, Start Keys light up orange, and a scan motion and copy cycle are stopped. When this happens, check the detail of the error and turn OFF, then ON, the Main Switch. If the same error message persists, call your Technical Representative and give him/her the error name and error number, together with the information on the DPCS3000 conditions. error name error number 5-1 PS3000 User's Manual Chapter 5 Troubleshooting Warning Message Book heigh is over 50 mm Possible Cause The height of the surface of the original is more than 50 mm above the Original Table. A tag or bookmark is on the book original. Action Lower the original so that its surface is in the range of height within 50 mm from the Original Table. [. . . ]