User manual KONICA MINOLTA ZOOM 70B

[. . . ] Keep batteries and other things that could be swallowed away from young children. â· The camera is dropped or subjected to an impact in which the interior is exposed. Electric shock may occur if a high voltage circuit inside the camera is touched. [. . . ] If blinks in the data panel with the other indicators, the battery will need to be replaced soon. If all indicators blink in the data panel or the camera will not function with a fresh battery, remove the battery, wait a few seconds, then reinsert it. To save power, your camera will shut down and the data panel indicator will disappear if it is not operated for more than 3 minutes. When film is in the camera, turn the camera off before removing the battery. If these steps are not followed, your camera may advance the film several frames, and reset the frame counter to one. Make sure is displayed in the frame counter, then slide the back-cover release down to open the back cover (D). Position the film between the film guide rails, so that it lays flat, or a film transport error may occur (G). â· If the film tip extends beyond the film-leader index, gently push the excess film back into the film cartridge. Looking through the viewfider, center your subject in the focus frame (H). When taking vertical pictures, hold the camera so the flash is on top. When the ready lamp glows, press the shutterrelease button all the way down with a slow steady squeeze to take the picture (J). When the ready lamp glows, without lifting your finger, recompose your picture (L). Press the shutter-release button all the way down to take the picture. â· Lift your finger from the shutter-release button to cancel focus hold. The flash will fire automatically when necessary, such as low-light situations indoors and before or after sunset. When the ready lamp glows brightly with the shutter-release button pressed partway down, press the shutter-release button the rest of the way down to take the picture. [. . . ] â· To cancel the self-timer, press the self-timer button again or turn the camera OFF. If the frame counter shows anything other than when the rewind motor stops, DO NOT OPEN THE BACK COVER. Replace the batteries, press the manual rewind button, and wait until appears and blinks in the data panel before opening the back cover. [. . . ]