User manual KRESS 1050 FME-1

[. . . ] Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. unmodified plugs and matching outlets will reduce risk of electric shock. Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is grounded. [. . . ] Mm 40 Milling-ø mm 36 Dimension mm 262x73 Weight kg 1, 4 Protection class II Milling and grinding motor 1050FME Input power Watt 1050 Output power Watt 600 Idle speed: 1050FME min-1 10. 800 Speed for rated load min-1 Tool fitting with collet chuck ø mm 8 Grinding tool ø, max. Mm 40 Milling-ø mm 36 Dimension mm 289x73 Weight kg 1, 7 Protection class II Your power tool is doubly insulated in compliance with EN 60745; there is thus no need for an earth wire. The machine is radio and TV interference-free in accordance with EN 55014-1 and interferenceproof in accordance with EN 55014-2. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. While reading the operating instructions, unfold the graphics page for the machine and leave it open. Device components 1 2 3 4 5 6 7 8 Locknut Collet chuck Spindle Locking button On/off switch Speed governor turning wheel Mains cable module Locking for mains cable module Illustrated or described accessories are not necessarily included in the scope of delivery Scope of supply See packaging The fitted milling and grinding motor is designed for milling wood and plastics and for grinding wood, plastic, steel and aluminium. The motor must not be guided by hand without appropriate milling attachments. Milling and grinding motor Input power Watt Output power Watt Idle speed min-1 Speed for rated load min-1 Noise levels Measurement values determined according to EN 60 745. Operation The A-weighted noise level of the device is typically: 78 dB(A) Sound pressure level (LpA) Sound power level (LwA) 89 dB(A) Measurement uncertainty K = 3 dB The noise level can exceed 85 dB(A) during operation. Vibration Triaxial vibration emission level determined in accordance with EN 60745. Milling ah m/s² 5, 0 Measurement uncertainty K m/s² 1, 5 The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. The vibration emission level will vary because of the ways in which a power tool can be used and may increase above the level given in this information sheet. This could lead to underestimation of vibration when the tool is used regularly in such a manner. Note: To be accurate, an estimation of the level of exposure to vibration experienced during a given period of work should also take into account the times when the tool is switched off and when it is running but not actually when doing the job. This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and accessories, keep the hands warm, organisation of work patterns. Before putting into operation, check that the mains voltage and frequency on the identification plate match the details of your mains supply. If the mains cable is damaged while working, pull the mains plug immediately. Fixed power supply Fixed power supply Damaged mains cables must not be used. [. . . ] Changing the collet Release the tightening nut 1 and remove the tool using suitable cut protection (Caution - Danger of injury). Using your thumb and index finger, press the collet 2 together at the continuous slot. Regularly wipe off the plastic parts which are accessible from the outside using a cloth without cleaning agent. Replacing brushes Worn carbon brushes should be replaced by an authorised customer service organisation. [. . . ]