User manual KRESS 108 ABL

[. . . ] Any power tool that cannot be controlled with the switch is dangerous and must be repaired. Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. [. . . ] During operation, always ensure that the mains and extension cable is to the rear away from the device. Move the switch to the "OFF" position before removing the plug from the plug socket. When the tool is reconnected to the mains accidental starting of the machine is avoided, thus reducing the risk of accidents. Tools not in use must be locked away safely in a dry place out of the reach of children. Use appropriate detectors to determine if utility lines are hidden in the work area or call the local utility company for assistance. The tool insert jams if: the power tool becomes overloaded or the tool tilts in the workpiece To mark the machine, do not drill into the housing. Operate the machine only with the auxiliary handle Loss of control can cause personal injury. Always assume a safe standing position and hold the power tool securely in both hands. Hold the power tool only by the insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own power cord. Contact with a "live" wire will also make exposed metal parts of the power tool "live" and lead to electric shock. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. Extend the depth stop 3 until the distance between the tip of the drill and the tip of the depth stop 3 corresponds to the required drilling depth X. ø in mm Your power tool is double-insulated in accordance with EN 60745; For this reason an earth wire is not required. The device is suppressed against radio and TV broadcasts, in accordance with EN 55014-1 and is immune to disturbances in accordance with EN 55014-2 If the mains cable is damaged while working, pull the mains plug immediately. Preselect speed (Option) In devices with a setting dial VII, you can select the speed using the setting dial VII depending on the area of application. Position "A" = lowest speed Position "G"= highest speed or = lowest speed = highest speed Change speed The On/Off switch VI can be used for infinitely variable speed control. Light pressure on the On/Off switch VI causes the machine to rotate slowly; with increased pressure, the speed increases. The motor can become overheated in case of continuous high load and low speeds. Mechanical gear selection (option) With the gear selector switch III you can preselect two speed ranges. Push the two unlocking buttons VIII and remove the mains cable module 4 from the handle. To limit dangerous reaction torques, the machine is equipped with a safety friction clutch. Always assume a safe standing position and hold the power tool securely in both hands. [. . . ] Spare parts / exploded view Exploded views and spare parts lists are available on our home-page www. This power tool has been carefully tested and has been subjected to a strict quality control process. We guarantee the free-of-charge repair of faults in the power tool that arise within 24 months from the date of purchase at the end user's premises and which can be attributed to a material or manufacturing defect. Inappropriate use or handling and opening up the device by unauthorised repair centres leads to the warranty becoming void. [. . . ]