User manual KRESS 800 PE

[. . . ] Before mounting tools in the drill chuck or spindle, always move the reversing switch (3) to the middle LOCK position, or disconnect the machine from the power supply, or remove the mains cable module (7) from the grip using the locking device button (8). Outside power sockets must be protected with residual-current-operated circuit-breakers (r. Double insulation Our equipment is designed in accordance with European regulations (EN standards) for the utmost safety of the user. Machines with double insulation always carry the in- Position 1 = least torque Position 10 = greatest torque The electronic system also has a gradual start up feature. [. . . ] This permits smooth drilling even when working with sensitive materials. The integrated electronic safety system prohibits start up in the case that the machine is plugged into the power supply with the trigger-switch locked in the ON/OFF position. The reversing switch is easiest to operate by using the thumb and index or middle finger from both sides. When using the drill as a screwdriver, the percussion mechanism must be switched off. When fixed in the middle LOCK position, the reversing switch prevents accidental startup of the full wave control (1), for example when changing tools or mounting/removing the drill chuck. Percussion drilling device The machine has an integrated percussion mechanism and can be switched from normal drilling to percussion drilling. The sliding switch (5) allows switching from normal drilling to percussion drilling or vice-versa while the machine is in operation. Mechanical two-speed gearshift Shifting takes place by turning the finger-grip knob (6) on the upper side of the machine. Position 1 = slow machine speed Position 2 = fast machine speed The two-speed gearing offers advantages for drilling and percussion drilling with small drill diameters up to c. Safety slip coupling The slip coupling takes effect as soon as a tool clamped in the machine becomes overloaded, is braked abruptly or jams. Although the motor and gear continue to run, the tool remains stationary. Replacing carbon brushes Our service personnel will do this and all other servicing work fast and professionally. This has been made very straightforward by the new mains cable module (6). Press both locking keys (7) and pull the mains cable module (6) out of the handle. Auxiliary handle For safety reasons, the supplementary handle must always be used when working with the percussion drilling machine. It allows safe, wander-free guidance of the drill and, thanks to an integrated depth stop, precise adjustment of the drilling depth. ensure that the draw spindle is properly tightened to the auxiliary handle. Only in this way can you prevent the auxiliary handle from twisting on the collar or becoming detached from the equipment. Supplied accessories Auxiliary handle with depth stop Noise/vibration information Measured values correspond with EN 50144. Sound pressure level: 1050 SXC = 74+3 dB (A) 800 PE = 78+3 dB (A) Sound power level: 1050 SXC = 87+3 dB (A) 800 PE = 91+3 dB (A) Work place emission value: 1050 SXC = 77+3 dB (A) 800 PE = 81+3 dB (A) Operators require noise protection equipment. Due to their modular construction Kress machines can be very easily broken down into their recyclable basic materials. Hand in your old Kress machine at a dealer or send them directly to Kress. [. . . ] Hand in your old Kress machine at a dealer or send them directly to Kress. Consignes de sécurité et protection contre les accidents Parcourir entièrement la notice d'utilisation avant de mettre la machine en service, suivre les consignes de sécurité de cette notice, de même que les consignes de sécurité générales relatives aux outils électriques dispensées dans la brochure fournie avec la notice. Om Ni använder maskinen mycket under en längre period, rekommenderar vi, vid tillfälle sända in den till vår service för en grundlig rengöring och inspektion. Lämna tillbaka skrotade Kressmaskiner till affären eller skicka in dem till Kress. [. . . ]