User manual KRESS APH 240

[. . . ] ­ Ensure that the connection between the battery charger and battery is correctly positioned and is not obstructed by foreign bodies. ­ Keep battery charger slot free of foreign objects and protect against dirt and humidity. ­ When the battery is outside the battery charger, cover battery terminals to avoid short circuits from metal objects. ­ When drilling or screwing in walls, they must be checked for hidden electric cables or water and gas pipes with a detector. [. . . ] After completion of the quick charging process, the charging unit switches automatically to trickle charging. Display and Key Constant green indicator light: The charging unit is correctly connected to the power mains and is ready for operation. no battery is inserted in the charging cavity or it is not making contact. Blinking green indicator light: The battery is making contact and quick charging is in progress. Constant green indicator light: The quick charging process has ended and the charging unit has switched to trickle charging. Rapid flashing green indicator light: The battery temperature is outside the allowable range. The charging process begins as soon as the battery temperature is again within the prescribed temperature range. The battery is defective or there is a short between the charging contacts. Should charging still not be possible, please send the battery and battery charger to our nearest service centre. Notes for the correct use of the battery: ­ To obtain the maximum service life, do not recharge the battery immediately after a short period of use but, if possible, discharge to the lower capacity limit and then recharge. The resulting excessive current flow leads to quick discharging and increased wear of the battery. ­ An increasingly shorter operating time per recharging of the battery is an indication that the battery is worn out and must be replaced. As a basic rule, return the faulty machine to our next customer service centre (also in the case of defective mains cables)!English Putting into Operation 9 Inserting/Removing Tools Before all work on the machine itself, always set the rotational direction switch 7 to the middle position. Only after the On/Off switch 6 is actuated and the machine starts does the gear box shift to the selected mode. When hammer drilling, use exclusively drills with hard metal inserts and SDS-Plus shafts. The use of commercially available masonry drills with cylindrical shafts by means of the adapter 18 and the normal drill chuck in conjunction with the pneumatic impact mechanism is not possible. With light pressure on the On/Off switch 6, the machine begins to rotate slowly; with increased pressure, the speed increases. If the rotational direction switch 7 is set between the positions "R" and "L", the machine cannot be switched on. For drilling work in metal, wood and plastic with drills that have normal shafts, a drill chuck (13 mm max. All common drill chucks with 1/2" × 20 UNF internal threads (13 mm max. Before all work on the machine itself, always set the rotational direction switch 7 to the middle position. [. . . ] Always hold the machine tightly with both hands and assume a secure stance. Lire entièrement la notice d'utilisation avant de mettre la machine en service, respecter les consignes de sécurité de cette notice, de même que les consignes de sécurité générales relatives aux outils électriques dispensées dans la brochure fournie avec la notice. Eller ännu bättre: Stick in batterimodulerna i den driftsklara batteriladdaren som är anslutet till el-nätet som efter avslutad laddning kopplar om till underhållsladdning. Efter kraftig påkänning under en längre period lämna in maskinen till en Kress-serviceverkstad för grundlig rengöring. [. . . ]