User manual LA CROSSE TECHNOLOGY TX25U INSTRUCTION MANUAL

[. . . ] An outdoor wall or window will have up to 20 feet of resistance and an interior wall will have up to 10 feet of resistance. Your distance plus resistance should not exceed 330 feet in a straight line. NOTE: Fog and mist will not harm your temperature sensor, but direct rain must be avoided. 2 DETAILED SETUP GUIDE I. Within 2 minutes of powering up the sensor, insert the batteries to the Weather Station (see "B. [. . . ] Once the batteries are in place, all segments of the LCD will light up briefly. Following the indoor temperature/humidity and the time as 12:00 will be displayed, and the signal reception icon will flash. If they are not shown in LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before reinserting them. The outdoor temperature from the first sensor (channel 1) should then be displayed on the Weather station. If this does not happen after 2 minutes, the batteries will need to be removed from both units and reset from step 1. If the temperature probe has been used, the outdoor temperature from channel 2 will then be displayed. Note: The temperature probe from the first sensor will always occupy "channel 2". If you choose not to use the temperature probe, Channel 2 will display "---". Insert the batteries to the second sensor as soon as the outdoor temperature readings from the first sensor are displayed on the Weather station. NOTE: You must insert the batteries into the second sensor within 30 seconds of reception of the first sensor. The outdoor temperature from the second sensor and the "channel 3" icon should then be displayed on the Weather station. If this does not happen after 2 minute, the batteries will need to be removed from all the units and reset from step 1. Note: only the readings from the internal sensor of the second sensor will be displayed in "channel 3" IMPORTANT: Transmission problems will arise if the setting for additional sensors is not followed as described above. Should transmission problems occur, it is necessary to remove the batteries from all units and start again the set-up from step 1. To view the temperature of a different remote temperature sensor unit, press and release the SET/CH button. A shift from one "boxed" number to the next should be observed in the OUTDOOR LCD. To determine which remote temperature sensor reading is displayed on the 3 channels, match the temperature displayed on each channel, with the corresponding temperature displayed on the LCD of each remote temperature sensor. To view the Minimum/Maximum temperature: first select which remote temperature sensor to read data from (indicated by the "boxed" number), then press the SET/CH button. Pressing this button once will display the minimum temperature, and the date and time the data was recorded. Pressing this button a second time (while "MIN" is still displayed, otherwise press the button twice) will display the same data for the maximum recordings. To reset the Minimum/Maximum readings, press and hold the MIN/MAX/+ button for 5 seconds, this will reset all the minimum and maximum data from all sensors. The mounting bracket can attach to the sensor in the middle of the back or on the bottom. [. . . ] The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. All replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd. Replacement parts and products assume the remaining original warranty, or ninety (90) days, whichever is longer. [. . . ]