User manual LA CROSSE TECHNOLOGY WS-9055TWC

[. . . ] To complete the set up of your indoor temperature station after the 15 minutes have passed please follow the steps in the detailed set up guide on page 8. INVENTORY OF CONTENTS 1. Instruction Manual and Warranty Card. 5 Figure 1 Figure 2 Holder ADDITIONAL EQUIPMENT (not included) 1. 2 Fresh AA Alkaline batteries DETAILED SETUP GUIDE Battery Installation 6 Install 2 AA batteries in the remote temperature sensor. Press and release the "+" key to advance the minutes. 7 7. Press and release the "SET" key to exit programming. FEATURES Minimum and Maximum Temperatures 1. [. . . ] The icons change in order, from "sunny" to "partly sunny" to "cloudy" or the reverse. It will not change from "sunny" directly to 12 "rainy", although it is possible for the change to occur quickly. If the symbols do not change then the weather has not changed, or the change has been slow and gradual. Weather Tendency Arrows Other possible displays in the FORECAST LCD are 2 weather tendency arrows, one that points up (on the left side of the LCD) and one that points down (on the right side of the LCD). An arrow pointing up indicates that the air pressure is increasing and the weather is expected to improve or remain good. An arrow pointing down indicates that the air pressure is decreasing and the weather is expected to become worse or remain poor. No arrow means the pressure is stable. 13 MOUNTING Note: To achieve a true temperature reading, avoid mounting in direct sunlight. We recommend that you mount the remote temperature sensor on a Northfacing wall. The sending range is 80ft; obstacles such as walls, concrete, and large metal objects will reduce the range. Place both units in their desired location before permanently mounting. Remote Temperature Sensor Remove the mounting bracket from the remote temperature sensor. Mount the bracket in the desired location with either screws or adhesive tape. Indoor Weather Station The indoor weather station comes with the table stand already mounted. If you wish to use the table-stand all that is 14 required is to place the indoor weather station in an appropriate location. To wall mount the indoor weather station first remove the table stand. Using the integrated hanging hole on the back of the unit, slip indoor weather station over the screw and pull down to secure. TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www. lacrossetechnology. com Problem: The LCD is faint Solution: Replace batteries Problem: No outdoor temperature is displayed. 15 Solution: 1. Remove all batteries, reinsert into remote temperature sensor first, then into the indoor weather station. Place remote temperature sensor and indoor weather station in position so the straight-line signal is not passing through more than two or three walls. Problem: Temperatures do not match if units are placed next to each other. Solution: Each temperature sensor is manufactured to be accurate to within 1 degree plus or minus and under normal conditions, so two sensors could be as much as 2 degrees different. However, the difference can be exaggerated further because the sensors are designed for different working environments. [. . . ] Replacement parts and products assume the remaining original warranty, or ninety (90) days, whichever is longer. La Crosse Technology, Ltd will pay all expenses for labor and materials for all repairs covered by this warranty. If necessary repairs are not covered by this warranty, or if a product is examined which is not in need or repair, you will be charged for the repairs or examination. The owner must pay any shipping charges incurred in getting your La Crosse Technology, Ltd product to a La Crosse Technology, Ltd authorized service center. [. . . ]