User manual LG GT5135SHES

[. . . ] If the remote control will not be used for a long time, remove the batteries. Users of this product are cautioned not to attempt repair of this product at their own discretion. Instead, they are requested to directly contact a designated service center or the outlet at which the product was purchased. If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. [. . . ] Increase the time in one-minute intervals Increase the time in ten-minute intervals Decrease the time in one-minute intervals Decrease the time in ten-minute intervals Result: AM or PM is displayed to indicate whether the setting corresponds to a time before or after midday. 4 When you are satisfied with your setting, confirm the time. To do so: using a small pointed tool (ball-point pen for example), press the button. Result: x The clock starts. Resetting the Time If you have already set the time but wish to change it, proceed as follow. 1 Using a small pointed tool (ball-point pen for example), press the button under the remote control flap. Result: 2 3 The AM or PM indication flashes. Set the time, following the instructions in Step 3 in the procedure above. To do so, press the button, using a small pointed tool (ball-point pen for example). x The clock starts. E-8 Selecting the Automatic Operating Mode You can start the air conditioner in Automatic mode from your remote control. In the Automatic mode, the standard temperature and the optimum fan speed is selected automatically. 1 If necessary, press the Result: (On/Off) button. x The OPERATION indicator on the indoor unit comes on. x The air conditioner starts up in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped It will start up normally after a three-minute. MODE TURBO OFF IM IMPORTANT 2 If the indication is not displayed at the top of the remote control, press the MODE button on the remote control one or more times until it appears. Just as the outer air flow blade can be adjusted vertically, the inner blades can be adjusted horizontally. 1 Open the air flow blade along the bottom of the indoor unit, by pressing the button. To stop the blade moving up and down, press the button again. 2 3 Adjust each set of inner blades to the required position, by pushing or pulling them sideways. E-14 Switching the Unit On and Off Automatically (On/Off Timer) You can set the timer to switch the air conditioner on and/or off automatically at given times. Example: You wish to start cooling your room before you return from work; you decide to: x Switch the air conditioner on at 5:30 p. m. You can set: x The switch-on time only x The switch-off time only x Both the switch-on and switch-off times IM IMPORTANT Check that the current time is correct before setting the timer; if it is not correct, refer to page 8 for details on how to set it. (On/Off) button. 1 2 If necessary, press the Select the required mode by pressing the MODE button on the remote control one or more times until the appropriate indication appears (in the above example, ). If you do not press a button within a few seconds, the Timer function is cancelled and you must press the button again. Hold down the w button. MODE TURBO 3 OFF 4 To set the switch-on time, press the To. . . Increase the time in ten-minute intervals Increase the time in one-hour intervals Decrease the time in ten-minute intervals Decrease the time in one-hour intervals Result: 5 AM or PM is displayed to indicate whether the setting corresponds to a time before or after midday. . When you are satisfied with the switch-on time, press Result: Note x The indoor unit beeps. If not necessary to operate the air conditioner until the set up time for starting, press (On/Off) button off. [. . . ] A water leakage or some other malfunction may happen if the heat exchanger freezes. Water may condense on and drip from the surface of the indoor unit if it is used for long periods. Indoor Humidity 80% or less - Low temperatures High humidity levels Mode Cooling Drying Outdoor Temperature 21°C to 43°C approx. 18°C to 43°C approx. If the cooling operation is used at over 33°C(indoor temperature) then, does not a full capacity. Cleaning Your Air Conditioner To get the best possible use out of your air conditioner, you must clean it regularly to remove the dust that accumulates on the air filter. IM IMPORTANT 1 Before cleaning your air conditioner, ensure that you have switched off the breaker used for the unit. Open the front grille by pulling on the tabs on the lower right and left sides of the indoor unit. [. . . ]