User manual LIFT-MASTER 64LM

[. . . ] Model 64LM 3-Button Mini Remote Control Owner's Manual The 64LM remote control has three buttons. [. . . ] Be careful to new remote control avoid moving the circuit board components. Place the new remote control and the original remote control side by side as shown (Figure 1) and set the switches in both remote controls to matching positions (+, 0, -). Use a pen or screwdriver to slide the code switches. AVERTISSEMENT Programming the opener RED-1 WHT-2 ATTENTION + 0 ­ 1 2 3 4 5 6 7 8 9 H I G H N ORM OR RED-1 WHT-2 H I G H N ORM NOTE: Code switch #1 in the Figure 2 3-button mini remote control is dormant, when used with a single-button remote control. Set code switch #1, in the single-button remote control, to match the push button selected on the 3-button mini remote control (Figure 2). Push Buttons (­) (+) (0) If your unit has a "Learn" button: Front View Side View Replacing the remote control battery WARNING To prevent possible SERIOUS INJURY or DEATH: · NEVER allow small children near batteries. · If battery is swallowed, immediately notify doctor. CAUTION 1. Press and release the "learn" button located on the back panel of the motor unit. Within the 30 second window, press and hold the button on the hand-held remote. The unit will either activate or the opener light bulb will blink signifying it has learned the code. H I G H N OR WARNING WARNING The 12 volt battery should provide power for up to 1 year. [. . . ] . 10A14 FOR SERVICE, DIAL OUR TOLL-FREE NUMBER: 1-800-528-2817 114A1212D © 2006, The Chamberlain Group, Inc. [. . . ]