User manual LIFT-MASTER ACRX 1000

[. . . ] Failure to install a reversing edge under these circumstances may result in serious injury or death to persons trapped beneath the door. FEATURES Code Memory 1000 users with unique radio codes (any combination of 60 Series remote controls, 80 Series remote controls, 66LM keypad remote control, or 99LM keypad remote control codes). Each radio code can have a 5 digit alpha-numeric user name assigned to it. Relay switching controlled by radio transmitters, or GRANT ACCESS button on control panel, or external push-button. The ACRx is mounted in an 8" x 10" x 3" metal box, with an integrated hinged lid. [. . . ] If you wish to leave the Setup mode without doing anything, press SETUP/EXIT again to return to the regular display, which shows the date and time alternately. Change PASSWORD: A password may be used to protect the ACRx against unauthorized access. To enable this feature, select a four digit password composed of letters and/or numbers. Once a password has been entered no changes can be made to the ACRx memory without supplying the password. Set the TIME: When "Set the TIME" is displayed and you press ENTER, the current time will be displayed in hour/minute/second/AM-PM format. Press SETUP/EXIT to return to the regular display. Set the DATE: When "Set the DATE" is displayed and you press ENTER, the current date will be displayed in month/day/year format. Set RELAY Mode: The method of relay operation depends on the type of gate or door opener the ACRx is controlling. The three types of operating modes are described as follows: · Momentary Close: The relay contacts will close for 1/3 seconds each time a valid user's transmitter code is received. This is the factory default state of the ACRx, and the most commonly used. · On When Receiving: The relay contacts will close when a valid transmitter code is received, and remain closed until the user releases his transmitter button. · Toggle ON/OFF: The relay contacts will close when a valid transmitter code is received, and remain closed until the next one is received. The relay will continue to toggle ON/OFF in this manner for each valid code received. This mode is useful when the relay must stay on after the user releases his transmitter button. Add User The display will show "DELETE <USER ID>?" Press ENTER to delete that User ID, or EXIT to cancel and start over. After ENTER is pressed, the display will flash "Del Usr COMPLETE". When a User ID is deleted, the ACRx will no longer respond to that transmitter and all record of that user is deleted from the ACRx. Block and Unblock Users Press the BLOCK USER button. Turn the knob until the first letter of the User ID is shown, then press ENTER. The display will show "BLOCK <USER ID>?" Press ENTER to temporarily block that User ID, or EXIT to cancel and start over. When a User ID is blocked, the ACRx will display the attempted entry as "BLOCKED:_____", and will not open the gate. Time and date of the attempted entry is available at the computer serial port. To unblock a user, press the BLOCK USER button and repeat the steps used to choose the User ID. The display will show "UNBLOCK <USER ID>?" Press ENTER to unblock that user, or EXIT to cancel and leave the user blocked. TRANSMITTER/WIRELESS OPERATION Each 80 series "Billion Code" transmitter is uniquely coded at the factory; no two transmitters have the same code. When adding a user there is no need to program the transmitter or set code switches. [. . . ] Set the DATE: When "Set the DATE" is displayed and you press ENTER, the current date will be displayed in month/day/year format. Turn the knob until the first letter of the User ID is shown, then press ENTER. The display will show "DELETE <USER ID>?" Press ENTER to delete that User ID, or EXIT to cancel and start over. After ENTER is pressed, the display will flash "Del Usr COMPLETE". [. . . ]