User manual LIFT-MASTER DC1000U

[. . . ] ® Installation for the DC1000UTM on the SL3000ULTM and SL3000ULDMTM TM STEP 1 STEP 2 STEP 3 SL3000ULTM ALIGN 3 PULLEYS STEP 4 PLUG-IN IC ST NG RI SL3000ULDMTM ALIGN 4 PULLEYS A PL Bolt the DC1000UTM into operator chassis, (Use 7/8" holes below idler sprockets). [. . . ] Install limit wires from DC1000UTM into bottom and out of the top back of the control box. Install DC1000UTM limit wires into limit box. See back for wiring new limit switches. Connect wires from DC1000UTM into terminal block on operator. (Polarity does NOT matter) 01-51125 © 2004 The Chamberlain Group, Inc. Then connect the BLUE wire from the DC1000UTM plug to the BLACK wire from the gate operator. (See back) Wiring the DC1000UTM to a: Main Style Commercial Board Wiring the DC1000UTM to a: OmniControlTM Board OFF ON Wiring the DC1000UTM to a: OmniControlTM Board with Surge Suppressor OFF ON Wiring Optional Equipment to the DC1000UTM All devices wired to the DC1000UTM are dedicated to it alone. Normal operation will be controlled by separate devices wired to the operator control board. J-1 Plug 10 8 6 4 2 J-1 Plug 10 8 CENTER J-1 Plug 2 10 8 CENTER 6 SAFETY 4 EXIT 6 SAFETY 4 EXIT 2 Close Buttons, Key Switches, Etc. DC1000UTM Plug 1 3 5 7 9 11 9 7 5 3 1 9 7 5 3 1 SENSOR ALARM 9 DC-BACKUP 7 5 3 1 2 DC-BACKUP SENSOR ALARM To Blue Wire To Black Wire W4 GBA MS LINK Cut Black Wire SENSORS To Blue Wire To Black Wire W4 GBA MS LINK Cut Black Wire SENSORS 4 6 8 10 12 SYSTEM ON TIMER 60 3 POWER OVERLOAD OPEN SYSTEM ON TIMER 60 3 POWER OVERLOAD REVERSE SENSOR REVERSE SENSOR ALARM SENSOR ALARM SENSOR 1 3 1 3 OFF OPEN LEFT ON OPEN RIGHT OFF OPEN LEFT ON OPEN RIGHT MADE IN USA MADE IN USA 1 3 1 3 1 3 1 3 Close Com Close Button Key Switch, Etc. [. . . ] All Rights Reserved Power Wires DC1000UTM Plug TM 845 Larch Avenue Elmhurst, Illinois 60126 www. chamberlain. com [. . . ]