User manual LUX ZE3 230-240V

[. . . ] Keep it in a safe place, wipe away any spillage at once and never leave the door open with detergent in the machine. iron debris, corrosive, acidic or alkaline chemicals must not be washed in this dishwasher. s Avoid opening the door while the machine is running. -3- Description of the appliance Rinse aid dispenser 1 Use of a rinse conditioner will result in cleaner and faster drying of the load, since it helps water and soil to run off. Too much conditioner may result in streakiness, too little may cause white spots. This is enough for 40-70 wash cycles, depending on the dosage setting. When the rinse conditioner level is approaching the bottom of the scale it is time to refill the dispenser. [. . . ] Swivel out the filler trough and carefully fill up with rinse conditioner until the level reaches the red mark on the level indicator tube. Do not overfill and carefully wipe off any spillage to prevent sudsing problems. Begin with the lowest dosage setting and increase as necessary by turning the arrow clockwise. Do not fill the rinse aid dispenser with liquid detergent. Coarse strainer 3 The purpose of the coarse strainer is to catch large objects, such as toothpicks and pieces of eggshell. Lift it out and rinse it under running water whenever necessary. Fine filter 4 It is just as important to keep this filter clean. The fine filter can easily be lifted out for cleaning when you have removed the coarse strainer. Detergent dispenser 5 Only use detergents specially designed for dishwashers. For a normal load pour about 1-2 tablespoons of detergent into the detergent dispenser. Spray arm 2 It is important to keep all the holes in the spray arm clear. If the spray arm needs cleaning, unscrew the nut clockwise (left-hand thread) and lift off the spray arm. Clear the holes and shake out any food remnants. -4- Controls and programme table All figures are nominal and vary for example due to temperature variations on the inlet water. The figures apply to washing up 5 IEC-settings. o 1 3 2 1 Temperature selector 55° - Button in 65° - Button out Door lock Press the handle down and open the door. Is the end of the drain hose submersed in waste water (in the sink?) Visible lime deposits or white film on the dishes. The machine is noisy. s Has the rinse aid run out or is too little being used? s Are the dishes rattling against each other?The door is difficult to close. Never attempt to repair the dishwasher yourself. Repairs carried out by unauthorised or inexperienced persons can cause injury or serious malfunctioning. -8- Service Service and spare parts Before calling service, use the trouble shooting table «If the machine is not working» to try to attend to the fault yourself. If service is called in to solve a problem that is in this list, there is a risk that you will be responsible for the cost. This is also true if you have used the appliance for a purpose other than it is intended for. Note that electrical faults should always be rectified by a certified electrician. Before calling the dealer or a service centre, make a note of the details on the data plate affixed to the rear of the dishwasher. Make a note of the following: TYPE MOD PROD. NO SER. NO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Purchase date. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Technical specifications DIMENSIONS Height Width Depth 460 mm 450 mm 480 mm WEIGHT Net Gross 17 kg 20 kg CAPACITY 5 standard IEC place settings WATER PRESSURES Minimum Maximum 50 kPa (0. 5 bar) 1000 kPa (10 bar) 65° C WATER TEMPERATURE Maximum ELECTRICAL DATA Power supply Fuse Heating element Power rating 220/230 V - 50 Hz 10 A 1200 W 1280 W -9- Unpacking the machine If the machine is damaged If the machine has been damaged during transportation, you should immediately notify the company responsible for delivering it. [. . . ] Make a note of the following: TYPE MOD PROD. NO SER. NO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Purchase date. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Technical specifications DIMENSIONS Height Width Depth 460 mm 450 mm 480 mm WEIGHT Net Gross 17 kg 20 kg CAPACITY 5 standard IEC place settings WATER PRESSURES Minimum Maximum 50 kPa (0. 5 bar) 1000 kPa (10 bar) 65° C WATER TEMPERATURE Maximum ELECTRICAL DATA Power supply Fuse Heating element Power rating 220/230 V - 50 Hz 10 A 1200 W 1280 W -9- Unpacking the machine If the machine is damaged If the machine has been damaged during transportation, you should immediately notify the company responsible for delivering it. If you discover any damage, faults or that anything is missing, you should notify the seller immediately. Never leave packaging material in a place where children may play with it. [. . . ]