User manual MAKITA 2414NBE

[. . . ] They are double-insulated and can, therefore, also be used from sockets without earth wire. The mains socket used for this device must be protected with a fuse or protective circuit breaker having slow tripping characteristics. Before using the tool on an actual workpiece, let it simply run for several minutes first. Watch for flutter or excessive vibration that might be caused by poor installation or a poorly balanced wheel. [. . . ] €¢ Always use only the proper inner and outer flanges which are provided with this tool. €¢ Always lower the safety guard after replacing the wheel. 2) CAUTION: • Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. For tool with lock button To start the tool, simply pull the switch trigger. For continuous operation, pull the switch trigger and then push in the lock button. To stop the tool from the locked position, pull the switch trigger fully, then release it. For tool with lock-off button To prevent the switch trigger from being accidentally pulled, a lock-off button is provided. To start the tool, depress the lock-off button and pull the switch trigger. 3) The spark guard is factory-installed with its lower edge contacting the base. Operating the tool in this position will cause many sparks to fly around. Loosen the screw and adjust the spark guard to a position at which minimum sparks will fly around. 9) By turning the vise handle counterclockwise and then flipping the vise nut to the left, the vise is released from the shaft threads and can be moved rapidly in and out. To grip workpieces, push the vise handle until the vise plate contacts the workpiece. Flip the vise nut to the right and then turn the vise handle clockwise to securely retain the workpiece. 6 CAUTION: • Always set the vise nut to the right fully when securing the workpiece. Failure to do so may result in insufficient securing of the workpiece. This could cause the workpiece to be ejected or cause a dangerous breakage of the wheel. When the cut-off wheel has worn down considerably, use a spacer block of sturdy, non-flammable material behind the workpiece as shown in the figure. You can more efficiently utilize the worn wheel by using the mid point on the periphery of the wheel to cut the workpiece. 11) If you use a spacer block which is slightly narrower than the workpiece as shown in the figure, you can also utilize the wheel economically. 12) Long workpieces must be supported by blocks of nonflammable material on either side so that it will be level with the base top. Switch on the tool and wait until the wheel attains full speed before lowering gently into the cut. [. . . ] If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. €¢ Abrasive cut-off wheels • Socket wrench 17 NOTE: • Some items in the list may be included in the tool package as standard accessories. ENG905-1 ENH003-13 For European countries only EC Declaration of Conformity We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Portable Cut-Off Model No. / Type: 2414NB are of series production and Conforms to the following European Directives: 2006/42/EC And are manufactured in accordance with the following standards or standardised documents: EN61029 The technical documentation is kept by our authorized representative in Europe who is: Makita International Europe Ltd. [. . . ]