User manual MAKITA 6825R

[. . . ] They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. Do not touch the bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. [. . . ] For continuous operation, pull the switch trigger and then push in the lock button. To stop the tool from the locked position, pull the switch trigger fully, then release it. nOTE: · Even with the switch on and motor running, the bit will not rotate until you fit the point of the bit in the screw head and apply forward pressure to engage the clutch. ⷠUse the reversing switch only after the tool comes to a complete stop. Charging the direction of rotation before the tool stops may damage the tool. When fitting the screw onto the point of the bit, be careful not to push in on the screw. If the screw is pushed in, the clutch will engage and the screw will rotate suddenly. Make sure that the bit is inserted straight in the screw head, or the screw and/or bit may be damaged. Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. When using the hook, pull it out in "A" direction and then push it in "B" direction to secure in place. When not using the hook, return it back to its initial position by following the above procedures in reverse. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. [. . . ] ⷠThe declared vibration emission value may also be used in a preliminary assessment of exposure. The vibration emission during actual use of the power tool can differ from the declared emission value depending on the ways in which the tool is used. ⷠBe sure to identify safety measures to protect the operator that are based on an estimation of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time). [. . . ]