User manual MAKITA 6836

[. . . ] Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. Safety hints For your own safety, please refer to the enclosed safety instructions. [. . . ] Then insert it through the feeder box until the first screw reaches the position next to the driving position. To remove the screw strip, just pull it out in the direction of the arrow. If you depress the reverse button, you can pull out the screw strip in the reverse direction of the arrow. 12) This tool can be used to drive at a position 15 mm away from the wall as shown in Fig. CAUTION: Driving at a position closer than 15 mm to the wall or driving with the stopper base in contact with the wall may damage the screw heads and cause wear on the bit. This may also lead to poor fastening of screws and malfunction of the tool. To remove it, pull it out in the direction of the arrow while raising. To install the hook, push it down until it "clicks" into place on the tool. Use of extension handle allows you to drive screws into floors while standing. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. For continuous operation, pull the trigger and then push in the lock button. To stop the tool from the locked position, pull the trigger fully, then release it. CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Center. ⷠUse the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. [. . . ] ­ The typical weighted root mean square acceleration value is not more than 2. For European countries only Noise and Vibration of Model 6834 The typical A-weighted sound pressure level is 81 dB (A). ­ The typical weighted root mean square acceleration value is not more than 2. [. . . ]