User manual MAKITA 6924N

[. . . ] € Due to our continuing program of research and development, the specifications herein are subject to change without notice. Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. [. . . ] 2) Press the pin down to remove the inner sleeve from the outer sleeve. 5 Installing the outer and inner sleeves Hold the inner sleeve with the pin facing upward. Press the pin to allow inserting the inner sleeve, then release the pin to secure the inner sleeve. 5) Insert the outer and inner sleeves into the tool while rotating the inner sleeve alternately clockwise and counterclockwise until there is no gap between the outer sleeve and the tool. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. 15) To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. ACCESSORIES CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. If you need any assistance for more details regarding these accessories, ask your local Makita service center. Sleeve Outer sleeve Inner sleeve Outer sleeve Inner sleeve Outer sleeve Inner sleeve Outer sleeve Inner sleeve Bolt size M22 M22 M24 M24 7/8” 7/8” 1” 1” Length (mm) 49 48 49 49 49 48 49 49 OPERATION Bolt installation Slip the tool onto the bolt so that the inner sleeve completely covers the bolt tip. [. . . ] 1) FÖRSIKTIGHET: • Kontrollera alltid att utlösaren för strömbrytaren aktiveras och återgår till läget "OFF" när den släpps, innan du ansluter verktyget till elnätet. μα Μέγεθος μπουλονιού M22 M22 M24 M24 7/8” 7/8” 1” 1” Μήκος (mm) 49 48 49 49 49 48 49 49 33 ENGLISH ENH101-6 ITALIANO ENH101-6 EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in compliance with the following standards of standardized documents; EN60745, EN55014, EN61000 in accordance with Council Directives, 89/336/EEC, 98/37/EC. [. . . ]