User manual MAKITA 9217SPC

[. . . ] Safety hints For your own safety, please refer to the enclosed safety instructions. Other personal protective equipment such as dust mask, gloves, helmet and apron should be worn when necessary. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. [. . . ] Always use the correct dust mask/respirator for the material and application you are working with. Ensure that ventilation openings are kept clear when working in dusty conditions. If it should become necessary to clear dust, first disconnect the tool from the main supply (use non metallic objects) and avoid damaging internal parts. Important: Always be sure that the tool is switched off and unplugged before installing or removing the disc. Fit the disc on over the rubber pad and screw the lock nut onto the spindle. Hold the spindle firmly with the wrench and tighten the lock nut using the lock nut wrench. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the ``OFF'' position when released. Keep the abrasive disc at an angle of about 10° ­ 15° to the workpiece surface. Excessive pressure will result in poor performance and premature wear to the abrasive disc. Important: Always be sure that the tool is switched off and unplugged before installing or removing the wool bonnet. Hold the spindle firmly with the wrench and tighten the lock nut using the lock nut wrench. Tie a bow knot and tuck the knot and any loose strings between the wool bonnet and the rubber pad. 3) The tool speed can be changed by moving the speed change switch to the ``L'' position or ``H'' position. High speed (3, 800 min-1): For sanding operation Low speed (2, 000 min-1): For polishing operation CAUTION: Use the speed change switch only after the tool comes to a complete stop. 4) The tool speed can be infinitely adjusted between 1, 500 rpm and 2, 800 rpm by turning the speed change knob. Refer to the table below for relationship between the number settings on the knob and the approx. [. . . ] The use of any other accessories or attachments might present a risk of injury to persons. The accessories or attachments should be used only in the proper and intended manner. : series production) manufactured by Makita Corporation in Japan is in compliance with the following standards or standardized documents, HD400, EN50144, EN55014, EN61000 in accordance with Council Directives, 73/23/EEC, 89/336/EEC and 98/37/EC. [. . . ]