User manual MAKITA 9501B

[. . . ] If devices are provided for the connection of dust extraction and collection ensure these are connected and properly used. Never carry the tool by the cord or yank it to disconnect from the socket. It is safer than using your hand and it frees both hands to operate the tool. Inspect tool cords periodically and if damaged have repaired by an authorized service facility. [. . . ] This tool is constructed in accordance with the relevant safety requirements. Repairs should only be carried out by qualified persons using original spare parts, otherwise this may result in considerable danger to the user. Ensure battery is disposed of safely as instructed by the manufacturer. ADDITIONAL SAFETY RULES 1. Other personal protective equipment such as dust mask, gloves, helmet and apron should be worn. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Use only wheels with correct size and wheels having a maximum operating speed at least as high as the highest No Load Speed marked on the tool's nameplate. When using depressed center wheels, be sure to use only fiberglassreinforced wheels. 6. ENB031-6 Check the wheel carefully for cracks or damage before operation. Observe the instructions of the manufacturer for correct mounting and use of wheels. Do not use separate reducing bushings or adaptors to adapt large hole abrasive wheels. Do not damage the spindle, the flange (especially the installing surface) or the lock nut. Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. 3. 4. 5. 8. 6. 4 SAVE THESE INSTRUCTIONS Tips for maintaining maximum battery life 1. Always stop tool operation and charge the battery cartridge when you notice less tool power. Charge the battery cartridge with room temperature at 10°C - 40°C (50°F - 104°F). Charge the Nickel Metal Hydride battery cartridge when you do not use it for more than six months. 2. 3. 4. 5 FUNCTIONAL DESCRIPTION · CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. 001018 Installing or removing battery cartridge · Always switch off the tool before insertion or removal of the battery cartridge. To remove the battery cartridge, pull out the set plate on the tool and grasp both sides of the cartridge while withdrawing it from the tool. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Be sure to close the set plate fully before using the tool to prevent the battery cartridge from accidentally falling out of the tool. If the cartridge does not slide in easily, it is not being inserted correctly. 1 2 · · 1. Battery cartridge · 001030 Shaft lock CAUTION: Never actuate the shaft lock when the spindle is moving. [. . . ] Fit the wheel and outer flange onto the spindle and temporarily secure with the screw. To tighten the screw, press the shaft lock firmly so that the spindle cannot revolve, then use the hex wrench to securely tighten the screw clockwise. Depressed center wheel 001092 To remove the wheel, follow the installation procedure in reverse. 1 2 3 1. Shaft lock 001118 Hex wrench storage When not in use, store the hex wrench as shown in the figure to keep it from being lost. 1 1. [. . . ]