User manual MAKITA 9563

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual MAKITA 9563. We hope that this MAKITA 9563 user guide will be useful to you.


MAKITA 9563 : Download the complete user guide (249 Ko)

You may also download the following manuals related to this product:

   MAKITA 9563 (249 ko)
   MAKITA 9563 (249 ko)
   MAKITA 9563 (249 ko)
   MAKITA 9563 (249 ko)
   MAKITA 9563 ANNEXE 274 (135 ko)
   MAKITA 9563 ANNEXE 488 (135 ko)

Manual abstract: user guide MAKITA 9563

Detailed instructions for use are in the User's Guide.

[. . . ] Power supply The machine should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. Safety hints For your own safety, please refer to the enclosed safety instructions. [. . . ] Hold the tool so that sparks fly away from you and other persons or flammable materials. Pay attention that the wheel continues to rotate after the tool is switched off. Do not touch the workpiece immediately after operation; it may be extremely hot and could burn your skin. Position the tool so that the power cord always stays behind the tool during operation. If working place is extremely hot and humid, or badly polluted by conductive dust, use a short-circuit breaker (30 mA) to assure operator safety. CAUTION: Before plugging in the tool, always check to see that the switch actuates properly and returns to the ``OFF'' position when the side of the switch lever is depressed. to start the tool , slide the switch lever to ``I'' position. For continuous operation, depress the front of the switch lever and then slide to ``I'' position as above. To stop the tool from the locked position, slide the switch lever to ``O'' position with depressing the rear of the switch lever. Important: Always be sure that the tool is switched off and unplugged before installing or removing the wheel guard. Pull the lever in the direction of the arrow after loosening the screw. Install the wheel cover on the bearing box by adjusting the convex of the wheel cover to the concave of the bearing box. Fasten it with the screw after pulling lever in the direction of the arrow for the working purpose, the setting angle of the wheel cover can be adjusted with the lever. CAUTION: After operation, always switch off the tool and wait until the wheel has come to a complete stop before putting the tool down. In general, keep the edge of the wheel or disc at an angle of about 15° ­ 30° to the workpiece surface. During the break-in period with a new wheel, do not work the tool in the B direction or it will cut into the workpiece. [. . . ] To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Center. Important: Always be sure that the tool is switched off and unplugged before installing or removing the wheel. Fit the wheel on over the inner flange and screw the lock nut onto the spindle. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE MAKITA 9563




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual MAKITA 9563 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.