User manual MAKITA 9566C

[. . . ] Do not use separate reducing bushings or adaptors to adapt large hole abrasive wheels. Do not damage the spindle, the flange (especially the installing surface) or the lock nut. For tools intended to be fitted with threaded hole wheel, ensure that the thread in the wheel is long enough to accept the spindle length. Before using the tool on an actual workpiece, test run the tool at the highest no load speed for at least 30 seconds in a safe position. [. . . ] Possible to get fine finish, because the rotating speed is kept constantly even under the loaded condition. Soft start feature Safety and soft start because of suppressed starting shock. Overload protector When the tool would be employed over the admissible load, it will stop automatically to protect the motor and wheel. When the load will come to the admissible level again, the tool can be started automatically. Press the shaft lock to prevent spindle rotation when installing or removing accessories. Important: Always be sure that the tool is switched off and unplugged before installing or removing the wheel. Fit the wheel on over the inner flange and screw the lock nut onto the spindle. To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise. CAUTION: After operation, always switch off the tool and wait until the wheel has come to a complete stop before putting the tool down. In general, keep the edge of the wheel or disc at an angle of about 15° ­ 30° to the workpiece surface. During the break-in period with a new wheel, do not work the tool in the B direction or it will cut into the workpiece. Once the edge of the wheel has been rounded off by use, the wheel may be worked in both A and B directions. Continued use of a worn-out wheel may result in wheel explosion and serious personal injury. CAUTION: Before plugging in the tool, always check to see that the switch actuates properly and returns to the ``O (OFF)'' position when the rear of the switch lever is depressed. to start the tool , slide the switch lever toward the ``I (ON)'' position. For continuous operation, press the front of the switch lever to lock it. CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. The tool and its opening vents for cooling air have to be always kept clean. To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Center. Important: Always be sure that the tool is switched off and unplugged before installing or removing the wheel guard. Pull the lever in the direction of the arrow after loosening the screw. Install the wheel cover on the bearing box by adjusting the convex of the wheel cover to the concave of the bearing box. [. . . ] Continued use of a worn-out wheel may result in wheel explosion and serious personal injury. CAUTION: Before plugging in the tool, always check to see that the switch actuates properly and returns to the ``O (OFF)'' position when the rear of the switch lever is depressed. to start the tool , slide the switch lever toward the ``I (ON)'' position. For continuous operation, press the front of the switch lever to lock it. [. . . ]