User manual MAKITA AH3655

[. . . ] String Press Chip receiver Nut Shear blade Branch catcher Hooks Fit the hooks into groove 31. Grooves Press the hooks on both sides Unlock the hooks Blade cover Screws Under cover Plate Crank Oval hole of shear blade Limit mark Holder cap cover Screwdriver Brush holder cap SPECIFICATIONS Model Blade length Strokes per minute (min-1) Overall length Net weight Rated voltage 1, 070 mm 5. 36V AH-3656 AH-3665 650 mm 1, 000 - 1, 800 1, 154 mm AH-3666 • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. €¢ Specifications and battery cartridge may differ from country to country. [. . . ] €¢ When the remaining battery capacity becomes low: Recharge the battery cartridge. 2) The handle can be rotated to either 90° left or right and mounted either 45° or 90° position to fit your work needs. First, pull the knob and rotate the handle clockwise or counterclockwise in the direction of arrow as shown in the figure. CAUTION: • Always make sure that the handle is locked in the desired position before operation. Switch action CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. 3) For your safety, this tool is equipped with a dual switching system. The sequence of switching is unimportant as the tool only starts when both switches are activated. Battery remaining capacity indicator (only for models with Battery AP-3622) Battery AP-3622 is equipped with the battery remaining capacity indicator. €¢ When only the lowermost indicator lamp (next to the “E”) blinks, or when none of the indicator lamps light, the battery capacity has run out, so the tool does not Speed change (Fig. 4) The strokes per minute can be adjusted just by turning the adjusting dial. In these cases, charge the battery or replace the empty battery with a fully charged one. €¢ When two or more indicator lamps do not light even after charging is complete, the battery has reached the end of its service life. €¢ When the upper two and lower two indicator lamps light alternately, the battery may have malfunctioned. NOTE: • The indicated capacity may be lower than the actual level during use or immediately after using the tool. €¢ Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. Attach firmly the arm cord hook band placing around your arm and pass the extension cord through the holder. NOTE: • Do not pass the extension cord through the band. OPERATION CAUTION: • Be careful not to accidentally contact a metal fence or other hard objects while trimming. €¢ Overreaching with a hedge trimmer, particularly from a ladder, is extremely dangerous. 9) Do not attempt to cut branches thicker than 10 mm diameter with this trimmer. These should first be cut with shears down to the hedge trimming level. CAUTION: • Do not cut off dead trees or similar hard objects. [. . . ] NOTE: • Before smearing the blade, remove the chip receiver. After operation, remove dust from both sides of the blade with wired brush, wipe off it with a rag and then apply enough low-viscosity oil, such as machine oil etc. Removing or installing shear blade CAUTION: • Before removing or installing shear blade, always be sure that the tool is switched off and the battery cartridge is removed. €¢ When replacing the shear blade, always wear gloves without removing blade cover so that hands and face does not directly contact the blade. [. . . ]