User manual MAKITA BDF441RFE

[. . . ] Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. [. . . ] The adjusting ring does not lock when the pointer is positioned only halfway between the graduations. Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. To change the speed, first switch off the tool and then slide the speed change lever to the "1" position for low speed, "2" position for medium speed or "3" position for high speed. Be sure that the speed change lever is set to the correct position before operation. nOTE: · When changing the position from "1" to "3" or from "3" to "1", it may be a little difficult to slide the speed change lever. At this time, switch on and run the tool for a second at the "2" position, then stop the tool and slide to your desired position. cAUTION: · Always set the speed change lever fully to the correct position. If you operate the tool with the speed change lever positioned halfway between the "1" position, "2" position and "3" position, the tool may be damaged. Insert the side grip so that the protrusions on the grip base fit in between the grooves on the tool barrel. Fit the bit holder into the protrusion at the tool foot on either right or left side and secure it with a screw. When changing the position from " " to " ", it may be a little difficult to slide the mode change lever. At this time, switch on and run the tool for a second at the " " position, then stop the tool and slide to your desired position. cAUTION: · Always slide the action mode change lever all the way to your desired mode position. If you operate the tool with the lever positioned halfway between the mode symbols, the tool may be damaged. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. Place the point of the driver bit in the screw head and apply pressure to the tool. nOTE: · Make sure that the driver bit is inserted straight in the screw head, or the screw and/or bit may be damaged. The fastening torque can be adjusted in 16 steps by turning the adjusting ring so that its graduations are aligned with the pointer on the tool body. first , slide the action mode change lever to the position of symbol. The fastening torque is minimum when the number 1 is aligned with the pointer, and maximum when the marking is aligned with the pointer. The clutch will slip at various torque levels when set at the number 1 to 16. Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. [. . . ] If you need any assistance for more details regarding these accessories, ask your local Makita service center. Om du ändrar läge från "1" till "3" eller från "3" till "1" kan det vara svårt att skjuta knappen till det nya läget. Om du ändrar läge från " " till " " kan det vara svårt att skjuta knappen till det nya läget. Se till att kolborstarnas lock passas in ordentligt i hålen i hållarna. [. . . ]