User manual MAKITA BFH040

[. . . ] A charger that may be suitable for one type of battery may create a risk of fire when used with another battery. Use battery operated tool only with specifically designated battery pack. Use clamps or other practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body is unstable and may lead to loss of control. [. . . ] ENC005-1 Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. Always switch off the tool before insertion or removal of the battery cartridge. To remove the battery cartridge, raise the interlock switch and withdraw it from the tool while sliding the button on the front of the cartridge. (Note: Battery cartridge cannot be removed without raising the interlock switch. ) To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Even if the switch trigger is pulled with the interlock switch raised, the tool does not start. (Note: The battery cartridge can be inserted even while the interlock switch is lowered. Once the battery cartridge is inserted, the interlock switch will rise automatically. If the cartridge does not slide in easily, it is not being inserted correctly. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. CAUTION: Do not look in the light or see the source of light directly. The light automatically goes out 10 seconds after the switch trigger is released. [. . . ] nOTE: · If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the bit will not be secured. In this case, try re-inserting the bit according to the instructions above. Align the yellow line with your desired number on the fastening torque scale. Insert the battery cartridge and be sure that a fastening torque has been set up by using a fastening torque tester. [. . . ]