User manual MAKITA BFL201F

[. . . ] Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. [. . . ] Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. Always stop tool operation and charge the battery cartridge when you notice less tool power. The light automatically goes out 10 seconds after the switch trigger is released. nOTE: · Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. Status of the LED indicator/beeper LED indicator Beeper Check LED, light and beeper (when pulling switch trigger for the first time after installing a battery cartridge into the tool). Make sure that green, red, blue, white LED lights up and beeper beeps properly. This function works when the tool has reached the preset fastening torque and normal tightening has been completed. This indicates the appropriate time to replace the battery cartridge when the battery power becomes low. This function works when an abnormal drop of the battery voltage occurs for some reason and the tool stops. This function works when the temperature of the controller or motor goes up very highly, and the tool stops. Fastening is incomplete when switch trigger of tool is released before clutch activation. Rotate the ring in the front of the tool by hand so that a hole can be seen below the ring. Insert the pin of the adjust grip into the hole in the front of the tool. And then, turn the adjust grip clockwise to set a greater fastening torque, and counterclockwise to set a smaller fastening torque. Align the edge of the adjust ring with your desired number on the fastening torque scale. Insert the battery cartridge and be sure that a fastening torque has been set up by using a fastening torque tester. Rotate the ring so that the hole for adjust grip is covered, hold and then secure the ring with screw. nOTE: · Numbers on the fastening torque scale is a guideline to set up your desired fastening torque. Use the tool within the range of the revolution angle up to 360°. If you use the tool beyond the upper limit of this range, the clutch does not work. [. . . ] Noise The typical A-weighted noise level determined according to EN60745: Model BFL201F, BFL402F Sound pressure level (LpA): 72 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). Model BFL301F Sound pressure level (LpA): 74 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Cordless Angle Screwdriver Model No. / Type: BFL201F, BFL301F, BFL402F are of series production and Conforms to the following European Directives: 2006/42/EC And are manufactured in accordance with the following standards or standardised documents: EN60745 The technical documentation is kept by our authorized representative in Europe who is: Makita International Europe Ltd. [. . . ]