User manual MAKITA BHP453RHJ

[. . . ] cutting accessory contacting a “live” wire may 4 IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CARTRIDGE ENC007-4 1. Before using battery cartridge, read all instructions and cautionary markings on (1) 2. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. [. . . ] For rotation with hammering, turn the ring so that the arrow points toward the mark on the ring. For rotation with clutch, turn the ring so that the arrow points toward the mark on the ring. CAUTION: • Always set the ring correctly to your desired mode mark. If you operate the tool with the ring positioned halfway between the mode marks, the tool may be damaged. 1) • Always switch off the tool before insertion or removal of the battery cartridge. € To remove the battery cartridge, withdraw it from the tool while sliding the button on the side of the cartridge. € To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. 6) The fastening torque can be adjusted in 16 steps by turning the adjusting ring so that its graduations are 5 aligned with the arrow on the tool body. The fastening torque is minimum when the number 1 is aligned with the arrow, and maximum when the number 16 is aligned with the arrow. Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. NOTE: • When driving wood screws, predrill pilot holes to make driving easier and to prevent splitting of the workpiece. Nominal diameter of wood Recommended size of pilot screw (mm) hole (mm) 3. 4 ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Drilling operation First, turn the adjusting ring so that the pointer points to the marking. CAUTION: • Pressing excessively on the tool will not speed up the drilling. In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the tool. € There is a tremendous force exerted on the tool/bit at the time of hole break through. Hold the tool firmly and exert care when the bit begins to break through the workpiece. € A stuck bit can be removed simply by setting the reversing switch to reverse rotation in order to back out. [. . . ] The use of any other accessories or attachments might present a risk of injury to persons. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. € Drill bits • Tungsten-carbide tipped hammer bit • Phillips bit • Slotted bit • Socket bit • Blow-out bulb • Safety goggles • Various type of Makita genuine batteries and chargers • Rubber pad assembly • Wool bonnet • Foam polishing pad • Plastic carrying case For Model BHP343 For European countries only Noise ENG104-1 The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA): 80 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). Vibration ENG203-2 The vibration total value (tri-axial vector sum) determined according to EN60745: Work mode: impact drilling into concrete Vibration emission (ah, ID): 10 m/s2 Uncertainty (K): 2. [. . . ]