User manual MAKITA BST110

[. . . ] Do not tamper with the tool or attempt to use it for other than driving staples. Stop driving operations immediately if you notice something wrong or out of the ordinary with the tool. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. [. . . ] If the staples have been handled roughly, they may be bent out of shape, causing poor staple feed or jamming. Do not use staples other than designated in this manual or staples that appear to be damaged, bent, rusty or corroded. â· Do not insert staples of which size is different each other at the same time inside the magazine, causing poor staple feed or jamming. Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Always switch off the tool before insertion or removal of the battery cartridge. â· To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. â· To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. â· Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. With the magazine loaded, if the tool is held downward and the sub-magazine is opened, the staples can fall out and present a danger to anyone or anything below. When removing staples, make sure that your fingers are not placed on the trigger or the lever and the battery cartridge is removed from the stapler. 2 & 3) Test safety systems for possible faulty operation before stapling as follows. Always make sure that your fingers are not placed on the trigger or the lever and the battery cartridge is removed before using the hook. Dropping the stapler, which is caused by the hook accidentally coming out of place, may cause misfiring and personal injuries. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. [. . . ] The grip is shaped so that the tool head can be held down securely with index finger and thumb. When the head of driven staple remains above the surface of material to be fastened, drive the staple while holding the stapler head firmly. When the trigger is pulled after a quick trigger action, the stapler may do nothing but operates momentarily and may not fire staples. At this time, release the trigger once, pull it again and the staples can be fired. [. . . ]