User manual MAKITA BST220

[. . . ] Do not point the ejection port at anyone in the vicinity (especially his face). Always remove the battery cartridge before loading the staples, adjustment, inspection, maintenance or after operation is over. Never attempt to drive staples from both the inside and outside of wall at the same time. Before using battery cartridge, read all instructions and cautionary markings on (1) It may result in a risk of overheating, possible burns and even an explosion. [. . . ] Always make sure that your fingers are not placed on the trigger and the battery cartridge is removed before carrying out any work on the stapler. If the staples have been handled roughly, they may be bent out of shape, causing poor staple feed or jamming. Do not use staples other than designated in this manual or staples that appear to be damaged, bent, rusty or corroded. â· Do not insert staples of which size is different each other at the same time inside the magazine , causing poor staple feed or jamming. Always stop tool operation and charge the battery cartridge when you notice less tool power. Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. With the magazine loaded, if the tool is held downward and the sub-magazine is opened, the staples can fall out and present a danger to anyone or anything below. Always switch off the tool before insertion or removal of the battery cartridge. â· To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. â· To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. When removing staples, make sure that your fingers are not placed on the trigger or the lever and the 5 Misfiring may cause personal injuries and property damage. Always make sure that the trigger are released and the battery cartridge is removed before removing jammed staples . Take out stuck staples that remain inside the opening that staples are fired from as it appears. Always make sure that your fingers are not placed on the trigger or the lever and the battery cartridge is removed before using the hook. Dropping the stapler, which is caused by the hook accidentally coming out of place, may cause misfiring and personal injuries. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. â· To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. [. . . ] Using the stapler continuously with the head of driven staples remaining above the surface of material to be fastened may cause damage to the driver of the stapler and stapler jamming etc. There is a convenient sight window on the right side of the tool (when viewing the tool from the front). When staples are not visible through the window, load staples into the magazine. The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. [. . . ]