User manual MAKITA BTP130

[. . . ] Fastening torque Machine screw Capacities Impact driver mode High tensile bolt No load speed (RPM) Impacts per minute No load speed (RPM) Hammer drill mode Blows per minute Capacities No load speed (RPM) Low (1) Drill mode Steel Capacities Wood No load speed (RPM) Screw driver mode Capacities Overall length Net weight Rated voltage Standard battery cartridge Machine screw M4 186 mm (7-3/8") 1. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. â· Note: Specifications may differ from country to country. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. [. . . ] If you can see the red part on the upper side of the button, it is not locked completely. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. If the cartridge does not slide in easily, it is not being inserted correctly. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. When not operating the tool, always set the reversing switch lever to the neutral position. CAUTION: Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. Select one of the four modes suitable for your work needs by using this lever. For rotation with impact, turn the lever so that the arrow on the lever points toward the mark on the tool body. Before operation, always make sure that the lever is correctly set to your desired mode mark and use the tool at an appropriate speed for your work. For rotation with hammering, turn the lever so that the arrow points toward the mark on the tool body. CAUTION: When using the action mode change lever, use only when the tool stops. But when the lever does not easily move, pull the switch trigger slightly to rotate the spindle and then move the lever. If you operate the tool with the lever positioned halfway between the mode marks, the tool may be damaged. For rotation with clutch, turn the lever so that the arrow points toward the mark on the tool body. For rotation only, turn the lever so that the arrow on the lever points toward the mark or the mark on the tool body. The fastening torque can be adjusted in 16 steps by turning the adjusting ring so that its graduations are aligned with the pointer on the tool body. The fastening torque is minimum when the number 1 is aligned with the pointer, and maximum when the number 16 is aligned with the pointer. The clutch will slip at various torque levels when set at the number 1 to 16. Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. [. . . ] â· CAUTION: Make sure that the driver bit is inserted straight in the screw head, or the screw and/or bit may be damaged. If the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery. If the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. [. . . ]