User manual MAKITA DA3011

[. . . ] Intended use This tool is intended for drilling in wood, metal and plastic. Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. [. . . ] If you use this power tool unsafely or incorrectly, you can suffer serious personal injury. Hold tool by insulated gripping surfaces when performing an operation where the cutting tools may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the opeator. Do not touch the drill bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. nOTE: · Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Avoid drilling in material that you suspect contains hidden nails or other things that may cause the bit to bind or break. Always be sure that the side grip is installed securely before operation. The side grip can be installed on either side of the tool, whichever is convenient. Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. To remove the bit, turn the chuck key counterclockwise in just one hole, then loosen the chuck by hand. These accessories or attachments are recommended for use with your Makita tool specified in this manual. [. . . ] ⷠA stuck bit can be removed simply by setting the reversing switch to reverse rotation in order to back out. ⷠAlways secure small workpieces in a vise or similar hold-down device. EC-DECLARATION OF CONFORMITY Model; DA3010, DA3010F, DA3011, DA3011F We declare under our sole responsibility that this product is in compliance with the following standards of standardized documents, EN60745, EN55014, EN61000 in accordance with Council Directives, 2004/108/EC and 98/37/EC. [. . . ]