User manual MAKITA DBC4010

[. . . ] Always follow safety precautions in the Owner's and Safety Manual. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. by choosing a MAKITA you have chosen one of the most advanced brushcutters. The DBC 3310, DBC4010 and DBC4510 brushcutters combine the benefits of state-of-the-art technology with ergonomic design, and are professional machines intended for all types of use. [. . . ] When installing the chisel type saw blade make sure that the direction of rotation arrows on saw blade and on cutter guard are pointing in the same direction!For safety reasons, this nut must be replaced immediately if it becomes loose. It must be replaced in any event after 10 tool changes at the latest (order no. Always install the metal cutter guard when installing the chisel type saw blade!Press the locking button (M/9) and hold it down while using the combination wrench to turn the shaft counter-clockwise until the locking button engages and locks the shaft. Now tighten the locknut counter-clockwise using the combination wrench (25-30 Nm). The locking button (M/9) will jump out (if necessary turn the saw blade slightly). In order to achieve easier operation along slopes and fitches, it is possible to swivel the gear box (N/13) from the normal position to either side by approximately 45 degrees. Loosen screw (N/15) enough to turn the gear box in the direction indicated by the arrow until the three boreholes are visible at the main tube. Turn the gear box in the direction indicated until the position of the screw (N/15) matches up with the borehole. Move the gear box back again and tighten the first screw (N/15) and subsequently the remaining two screws (N/14) by the same amount. If your skin comes in contact with these substances repeatedly and for an extended period of time, it will desiccate. The engine was designed for regular lead-free gasoline with an octane number of at least 91 ROZ. To obtain optimum engine operation and to protect your health and the environment, only unleaded fuel should be used!For lubricating the engine use a two-stroke engine oil (quality grade: API-TC), which is added to the fuel. The engine has been designed for use of MAKITA HP 100 high-performance two-stroke engine oil and a mixture ratio of only 100:1 to protect the environment. In addition, a long service life and reliable operation with a minimum emission of exhaust gases are ensured. MAKITA HP 100 high-performance two-stroke engine oil is available in the following sizes: 0. 980 008 609 MAKITA high-performance two-stroke engine oil is available in two different sizes: 1 l part no. Therefore fuel and fuel mixtures, which have been stored for too long, can cause starting problems. Purchase only that amount of fuel, which will be consumed over the next few months. In case MAKITA high-performance two-stroke engine oil is not available, it is urgently recommended to use a mixture ratio of 40:1 with other two-stroke engine oils, as otherwise optimum operation of the engine cannot be guaranteed. [. . . ] The next time you use the brushcutter, purchase new fuel and prepare the two-stroke mixture as specified. To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be performed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Clean Check for damage and sharpness Check (cutting tool must not move) Empty Run empty The maintenance and repair modern brushcutters and safety-related components and assemblies requires qualified technical training and a workshop equipped with special tools and testing devices. [. . . ]