User manual MAKITA DHR202RMJ

[. . . ] In cold weather or when the tool has not been used for a long time, let the tool warm up for a while by operating it under no load. Do not touch the bit or parts close to the bit immediately after operation; they may be extremely hot and could burn your skin. Always stop tool operation and charge the battery cartridge when you notice less tool power. Charge the battery cartridge with room temperature at 10°C – 40°C (50°F – 104°F). [. . . ] 6 In this situation, release the trigger switch on the tool and stop the application that caused the tool to become overloaded. In this situation, let the battery cool before pulling the trigger switch again. € Low battery voltage: The remaining battery capacity is too low and the tool will not operate. 5) CAUTION: • Do not look in the light or see the source of light directly. The light automatically goes out 10 – 15 seconds after the switch trigger is released. NOTE: • Use a dry cloth to wipe the dirt off the lens of the lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. 3) (Only for battery cartridges with “B” at the end of the model number. ) Press the check button on the battery cartridge to indicate the remaining battery capacity. indicator lamps Remaining capacity Lighted Off Blinking 75% to 100% 50% to 75% 25% to 50% 0% to 25% Charge the battery. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. CAUTION: • Always check the direction of rotation before operation. € Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. € When not operating the tool, always set the reversing switch lever to the neutral position. , depress the lock button and rotate the action mode changing knob to the symbol. 8) For drilling in wood, metal or plastic materials, depress the lock button and rotate the action mode changing knob to the m symbol. CAUTION: • Do not rotate the action mode changing knob when the tool is running. NOTE: • Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. 4) CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. The torque limiter will actuate when a certain torque level is reached. [. . . ] ENH101-18 ENG901-1 OPTIONAL ACCESSORIES CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. € • • • • • • • • • • • • • • SDS-Plus Carbide-tipped bits Drill chuck assembly Drill chuck S13 Chuck adapter Chuck key S13 Bit grease Side grip Depth gauge Blow-out bulb Dust cup Dust extractor attachment Safety goggles Plastic carrying case Keyless drill chuck Makita genuine battery and charger For European countries only EC Declaration of Conformity Makita declares that the following Machine(s): Designation of Machine: Cordless Rotary Hammer Model No. [. . . ]