User manual MAKITA EA4300F

[. . . ] 5) Before use, always inspect the machine, especially the condition of the blades, and check that the screws and cutting assembly are not worn or damaged. replace worn or damaged blades and screws in sets to preserve balance. 6) Before mowing, attach the discharge opening guards (grasscatcher or stone-guard). Safety devices, such as the stone-guard and/or grass-catcher, in place. [. . . ] 4) To reduce the fire hazard, keep the engine, exhaust silencer, battery compartment and fuel storage area free of grass, leaves, or excessive grease. 5) Check the stone-guard and grass-catcher frequently for wear and deterioration. 6) If the fuel tank has to be drained, this should be done outdoors and when the engine is cool. All operations on the blade (dismantling, sharpening, balancing, remounting and/or replacing) require a certain familiarity and special tools. 9) For reasons of safety, do not use the equipment with worn or damaged parts. Parts that are not of the same quality can damage the equipment and be dangerous for your safety. C) OPERATION 1) Do not operate the engine in a confined space where dangerous carbon monoxide fumes can collect. 5) Walk, never run and do not allow yourself to be pulled along by the lawnmower. 10) Stop the blade if the lawnmower has to be tilted for transportation when crossing surfaces other than grass, and when transporting the lawnmower to and from the area to be mowed. € use an appropriate number of people for the weight of the machine and the characteristics of the vehicle or the place where it has to be placed or collected. 18 GB STANDARDS OF USE For instructions regarding the engine and the battery (if supplied), read the relevant manuals. 4 The speed changer (if fitted) is controlled by moving the lever to one of the four positions, marked as: 1 - 2 - 3 - 4 The move from one speed to another must be made with the engine running and drive engaged. IMPORTANT - Do not touch the speed changer when the engine is stopped. 5 The cutting height is adjusted by releasing the lever (1) and lifting or lowering the chassis to the required position which can be seen through the special opening. 1 All operations on the blade should be carried out at a specialized centre. 2 In power-driven models: • adjust the tension of the belt with the nut (1) to get the right measurement (6 mm). € turn the adjusting nut (2) so that the wire (3) is slightly loose and the lever (4) is idle. 4 To recharge a flat battery, connect to the battery charger (1) following the instructions in the battery maintenance handbook. It is not possible to start the engine using the battery charger as a power source, as it may get damaged. If the machine is to remain inactive for a long period, disconnect the battery leads after making sure that the battery is fully charged. 5 To clean inside the machine, use the hosepipe connector (1) provided. 1 Lift the stone-guard and attach the grass-catcher (1) correctly as shown in the drawing. [. . . ] Cleaning, servicing and adjustment work is not covered by the guarantee. All repairs covered by the guarantee must be performed by a DOLMAR service centre. Responsibility On tools with engines by Briggs&Stratton, Honda, Tecumseh or Robin Subaru, the engine manufacturer or their authorised service centre is responsible for the engine only. DOLMAR is responsible for the rest of the tool (excluding the engine). [. . . ]