User manual MAKITA EBH341R ANNEXE 574

[. . . ] Warning Read this instruction manual carefully before putting the Brush Cutter into operation and strictly observe the safety regulations!We are pleased to be able to you the MAKITA Brush Cutter which is the result of a long development programme and many years of knowledge and experience. Please read, understand and follow this booklet which refers in detail to the various points that will demonstrate its outstanding performance. This will assist you to safely obtain the best possible result from your MAKITA Brush Cutter. [. . . ] CONNECTION OF SWITCH CORD ­ Connect the switch cords to the two cords from the engine by inserting one into the other. ⭠For this brush cutter , we recommend the cutting attachments on the right. ­ Never attempt to cut a tree, a log, wood or other hard materials. [Tightening torque: 28 ­ 48 N m] NOTE : Always wear gloves when handling the cutter blade. Mounting of nylon cutting head ­ The blade cap, bolt cover and nut are not necessary for mounting the nylon cutting head. ­ Insert the allen wrench through the hole in the gear case and rotate the blade holder until it is locked with the alln wrench. ­ Then screw the nylon cutting head onto the shaft by turning it counter-clockwise. Nut Bolt cover Blade cap Blade Grass cover Blade holder Protector plate Protector ­ Perform the following procedure, with the engine cooled down. ­ While keeping the engine level, remove the oil gauge, and confirm that the oil is filled within the upper and lower limit marks. When the oil is in short in such a way that the oil gauge touches the oil only by its tip, in particular with the oil gauge remaining inserted in the crankcase without screwing-in (Fig. ­ For reference, the oil refill time is about 15 h (refill frequency: 15 times). ­ If the oil changes in color or mixes with dirt, replace it with new one. 17) Recommended oil: SAE 10W-30 oil of API Classification, Class SF or higher (4-stroke engine for automobile) Oil volume: Approx. 1 L Note: If the engine is not kept upright, oil may go into around the engine, and may be refilled excessively. If the oil is filled above the limit, the oil may be contaminated or may catch fire with white. Point 1 in Replacement of Oil "Oil Gauge" ­ Remove dust or dirt near the oil refill port, and detach the oil gauge. Otherwise, any sand or dust adhering to the oil gauge may cause irregular oil circulation or wear on the engine parts, which will result in troubles. ­ As an example to keep the oil gauge clean, it is recommended to insert the oil gauge on its knob side into the engine cover, as shown in Fig. Upper limit of oil level (Lower part of oil refill port threaded part) If oil adheres around this tip refill new oil. ­ If oil spills out between the fuel tank and engine main unit, the oil is sucked into through the cooling air intake port, which will contaminate the engine. Refueling must be performed in a sufficiently ventilated room or in the open air. If you touch fuel repeatedly or for a long time, the skin becomes dry, which may cause skin disease or allergy. [. . . ] Any maintenance of adjustment work that is not been included and described in this manual is only to be performed by Authorized Service Agents. WARNING: When draining the fuel, be sure to stop the engine and confirm that the engine cools down. Just after stopping the engine, it may still hot with possibility of burns, inflammability and fire. ATTENTION: When the machine is kept out of operation for a long time, drain up all fuel from the fuel tank and carburetor, and keep it at a dry and clean place. [. . . ]