User manual MAKITA GA5030RK

[. . . ] Use only wheels with correct size and wheels having a maximum operating speed at least as high as the highest No Load Speed marked on the tool’s nameplate. Observe the instructions of the manufacturer for correct mounting and use of wheels. Before using the tool on an actual workpiece, test run the tool at the highest no load speed for at least 30 seconds in a safe position. [. . . ] CAUTION: • Use the correct size collet cone for the wheel point which you intend to use. OPERATION Turn the tool on without the wheel point making any contact with the workpiece and wait until the wheel point attains full speed. To obtain a good finish, move the tool in the leftward direction slowly. Excessive pressure on the tool will only cause a poor finish and overloading of the motor. SAVE THESE INSTRUCTIONS FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. MAINTENANCE CAUTION: • Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. 1) CAUTION: • Before plugging in the tool, always check to see that the switch lever actuates properly and returns to the “OFF” position when released. € Do not pull the switch lever forcibly without pushing in the lock-off lever. For tool with lock button To prevent the switch lever from accidentally pulled, a lock-off lever is provided. To start the tool, pull the lock-off lever toward the operator and then pull the switch lever. For continuous operation, pull the switch lever and then push in the lock button. To stop the tool from the locked position, pull the switch lever fully, then release it. For tool without lock button To prevent the switch lever from accidentally pulled, a lock-off lever is provided. To start the tool, pull the lock-off lever toward the operator and then pull the switch lever. ACCESSORIES CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. [. . . ] € Innan du ansluter maskinen till elnätet ska du alltid kontrollera att avtryckaren fungerar och återgår till läget "OFF" när du släpper den. Använd den ena nyckeln till att hålla fast spindeln och den andra till att dra fast hylsmuttern. ς • Κλειδί 13 • Σετ πλαϊνής λαβής 35 ENGLISH For European countries only Noise and Vibration The typical A-weighted sound pressure level is 73 dB (A). [. . . ]