User manual MAKITA HM1303B

[. . . ] Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can be operated on single-phase AC/DC supply. [. . . ] To securely retain the bit, return the tool retainer to its original position. CAUTION: Always assure that the bit is securely retained by attempting to pull the bit out of the tool holder after completing the above procedure. With the notched portion of the bit facing the tool retainer shaft, insert the bit into the tool holder as far as it will go. Then pivot the tool retainer further downward toward the barrel to securely retain the bit. Always assure that the bit is securely retained by attempting to pull the bit out of the tool holder after completing the above procedure. The bit without a collar cannot be retained by the method shown in Fig. Turn the tool on and apply slight pressure on the tool so that the tool will not bounce around, uncontrolled. CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Whenever carbon brushes must be replaced, they cut out the tool automatically. When this occurs, remove the holder cap plates and then replace both carbon brushes at the same time. This tool requires no hourly or daily lubrication because it has a grease-packed lubrication system. Remove the plate 50 using a screwdriver, then replenish with fresh grease (15 g). To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Centre. The side handle can be either freely swivelled or secured at one position for use during tool operation. [. . . ] EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in compliance with the following standards or standardized documents, HD400, EN50144, EN55014, EN61000 in accordance with Council Directives, 73/23/EEC, 89/336/EEC and 98/37/EC. Measured sound power level: 103 dB Guaranteed sound power level: 107 dB These sound power levels are measured in accordance with Council Directive, 2000/14/EC. [. . . ]