User manual MAKITA HR2440

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual MAKITA HR2440. We hope that this MAKITA HR2440 user guide will be useful to you.


MAKITA HR2440 : Download the complete user guide (877 Ko)

You may also download the following manuals related to this product:

   MAKITA HR2440 (926 ko)
   MAKITA HR2440 (926 ko)
   MAKITA HR2440 (926 ko)
   MAKITA HR2440 (926 ko)
   MAKITA HR2440 ANNEXE 694 (187 ko)
   MAKITA HR2440 ANNEXE 603 (187 ko)

Manual abstract: user guide MAKITA HR2440

Detailed instructions for use are in the User's Guide.

[. . . ] Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. Safety hints For your own safety, please refer to the enclosed safety instructions. Hold tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. [. . . ] cAUTION: · Always set the knob fully to your desired mode symbol. If you operate the tool with the knob positioned halfway between the mode symbols, the tool may be damaged. NOTE: The depth gauge cannot be used at the position where the depth gauge strikes against the gear housing. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. for Model HR2440 , HR2440X , HR2440F and HR2441 To start the tool , simply pull the switch trigger. For continuous operation, pull the switch trigger and then push in the lock button. To stop the tool from the locked position, pull the switch trigger fully, then release it. For continuous operation, pull the switch trigger and then push in the lock button. To stop the tool from the locked position, pull the switch trigger fully, then release it. 6) For Model HR2440F CAUTION: Do not look in the light or see the source of light directly. Be careful not to scratch the lens of lamp, or it may lower the illumination. The torque limiter will actuate when a certain torque level is reached. As soon as the torque limiter actuates, switch off the tool immediately. Keep the tool in position and prevent it from slipping away from the hole. Do not apply more pressure when the hole becomes clogged with chips or particles. Instead, run the tool at an idle, then remove the bit partially from the hole. By repeating this several times, the hole will be cleaned out and normal drilling may be resumed. CAUTION: There is tremendous and sudden twisting force exerted on the tool/bit at the time of hole breakthrough, when the hole becomes clogged with chips and particles, or when striking reinforcing rods embedded in the concrete. Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during operations. Coat the bit shank head beforehand with a small amount of bit grease (about 0. [. . . ] I metall kan du borra upp till 13 mm i diameter, och i trä upp till 32 mm i diameter. CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. The accessories or attachments should be used only in the proper and intended manner. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE MAKITA HR2440




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual MAKITA HR2440 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.