User manual MAKITA HR2450X

[. . . ] It is also suitable for drilling without impact in wood, metal, ceramic and plastic. Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. Safety hints For your own safety, please refer to the enclosed safety instructions. [. . . ] To avoid rapid wear on the mode change mechanism, be sure that the action mode changing knob is always positively located in one of the three action mode positions. NOTE: The depth gauge cannot be used at the position where the depth gauge strikes against the gear housing. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. For continuous operation, pull the switch trigger and then push in the lock button. To stop the tool from the locked position, pull the switch trigger fully, then release it. 8) For model HR2450F CAUTION: Do not look in the light or see the source of light directly. Be careful not to scratch the lens of lamp, or it may lower the illumination. The torque limiter will actuate when a certain torque level is reached. As soon as the torque limiter actuates, switch off the tool immediately. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. When you operate the tool in counterclockwise rotation, the switch trigger is pulled only halfway and the tool runs at half speed. Keep the tool in position and prevent it from slipping away from the hole. Do not apply more pressure when the hole becomes clogged with chips or particles. Instead, run the tool at an idle, then remove the bit partially from the hole. By repeating this several times, the hole will be cleaned out and normal drilling may be resumed. CAUTION: There is tremendous and sudden twisting force exerted on the tool/bit at the time of hole breakthrough, when the hole becomes clogged with chips and particles, or when striking reinforcing rods embedded in the concrete. Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during operations. Coat the bit shank head beforehand with a small amount of bit grease (about 0. Use the dust cup to prevent dust from falling over the tool and on yourself when performing overhead drilling operations. [. . . ] I metall kan du borra upp till 13 mm i diameter, och i trä upp till 32 mm i diameter. CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. The accessories or attachments should be used only in the proper and intended manner. [. . . ]