User manual MAKITA HTR4901

[. . . ] WARNING: To reduce the RISK of injury, user must read and understand the instruction manual before using the Hedge Trimmer. manufacturer reserves the right to change specifications without notice. We are pleased to be able to offer you the MAKITA Hedge Trimmer which is the result of a long development program and many ears of knowledge and experience. The Hedge Trimmer models HTR4901 combines the advantages of state-of-the-art technology with ergonomic design, they are light weight, handy, compact and represent professional equipment for a great variety of applications. [. . . ] To obtain optimum engine operation and to protect your health and the environment, only unleaded fuel should be used!For lubricating the engine use a two-stroke engine oil (quality grade:TSC-3), which is added to the fuel. The engine has been designed for use with MAKITA two-stroke engine oil and a mixture ratio of 50:1 only to protect the environment. In addition, a long service life and a reliable operation with a minumum emission of exhaust gases is guaranteed. It is absolutely essential to observe a mixture ratio of 50:1 (MAKITA 2-stroke engine oil), otherwise the reliable function of the Hedge Trimmer cannot be guaranteed. The correct mixture ratio: Gasoline : Makita genuine two-stroke engine oil = 50 : 1 or Gasoline : Other manufacturer's two-stroke engine oil = 25 : 1 recommended NOTE: For preparing the fuel-oil mixture, first mix the entire oil quantity with half of the fuel required. In an approved can which meets of exceeds all local code standards, then add the remaining fuel. Thoroughly shake the mixture before filling it into the Hedge Trimmer's tank. It is not wise to add more engine oil than specified to ensure safe operation. It will only result in a higher production of combustion residues which will pollute the environment and clog the exhaust channel in the cylinder as well as the muffler. Do not inhale fuel vapors, avoid any contact of fuel or oil with your skin. If your skin comes in contact with these substances repeatedly and for an extended period of time, it will desiccate. Stop the engine during refuelling, keep away from naked flames and do not smoke. Take care not to spill either fuel or oil in order to prevent soil contamination (enviromental protection). Place the Hedge Trimmer on a clean area of ground make sure that the cutting tool does not come into contact with the ground or any other objects. Cold starting (When the engine is cold or it has been stopped for more than 5 minutes or when fuel is added to the engine. Give a gentle push on the primer pump (2) repeatedly (7 to 10 times) until fuel comes into the primer pump. Hold the unit down firmly so you will not lose control while cranking the engine. If not held down properly, the engine could pull you off balance or swing the cutting blade into an obstruction or your body. Pull the starter handle slowly for 10 to 15 cm, and check the location of pressure. " Please note that the choke lever will return to " " position automatically when the throttle lever is operated and the throttle is opened. Run the engine for approximately one minute at a moderate speed before applying full speed. [. . . ] After cleaning, put back the sponge element and the air cleaner cover. NOTE: If there is excessive dust or dirt adhering to the air cleaner, clean it every day. A clogged air cleaner may make it difficult or impossible to start the engine or increase the engine rotation speed which could cause damage. If the spark plug is clogged with carbon or fouled, clean it thoroughly or replace it. [. . . ]