User manual MAKITA JV100D

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring. Cutting accessory contacting a “live” wire may make exposed metal parts of the power tool “live” and could give the operator an electric shock. 5 WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. [. . . ] 3) CAUTION: • Before installing the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. €¢ When not operating the tool, depress the lock-off button from A side to lock the switch trigger in the OFF position. To prevent the switch trigger from accidentally pulled, the lock-off button is provided. To start the tool, depress the lock-off button from B side and pull the switch trigger. OPERATION CAUTION: • Always hold the base flush with the workpiece. Failure to do so may cause blade breakage, resulting in a serious injury. €¢ Advance the tool very slowly when cutting curves or scrolling. Forcing the tool may cause a slanted cutting surface and blade breakage. Turn the tool on without the blade making any contact and wait until the blade attains full speed. Then rest the tool base flat on the workpiece and gently move the tool forward along the previously marked cutting line. 9, 10 & 11) CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before tilting the base. €¢ Raise the dust cover all the way before making bevel cuts. With the base tilted, you can make bevel cuts at any angle between 0° and 45° (left or right). Move the tool base so that the bolt is positioned in the center of the cross-shaped slot in the base. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. 4 & 5) CAUTION: • Always clean out all chips or foreign matter adhering to the blade and/or blade holder. Failure to do so may cause insufficient tightening of the blade, resulting in a serious personal injury. €¢ Do not touch the blade or the workpiece immediately after operation; they may be extremely hot and could burn your skin. Insufficient tightening of the blade may cause blade breakage or serious personal injury. Using blades other than B type blades causes insufficient tightening of the blade, resulting in a serious personal injury. [. . . ] Insert the circular guide pin through either of the two holes on the fence guide. Now slide the rip fence to the desired cutting radius, and tighten the bolt to secure it in place. NOTE: • Some items in the list may be included in the tool package as standard accessories. 19 & 20) Noise The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA): 76 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). [. . . ]