User manual MAKITA LS0711B

[. . . ] 1 2 3 4 5 6 7 Frame Bolts Support Inner grooves (A) Outer grooves (B) Frame pipe Lock plate 8 9 10 11 12 13 14 Support plate (For LS0714 only) The smallest hole in the support Adjusting bolt Front holes in your tool base Front holes in the supports Bolt Nut 15 16 17 18 19 20 Fix plates Outer hole (a) Inner hole (b) The largest holes Outer frame Inner frame Read and thoroughly understand this manual and the instruction manual of the tool you use before performing the following. â· Before installing a tool on this stand, always switch off and unplug the tool. [. . . ] When the stand cannot be set up stable, turn the adjusting bolt at the foot of stand for proper stability. Secure the feet of stand to the stable and level surface using holes in the fix plates with three hex bolts. CAUTION: When using the thicknesser or planer specified in this manual, set up the stand in the low position mode. Change the installation position of the lock plate from the outer hole (a) to the inner hole (b) and retighten the bolt firmly. Close the frame slightly, raise the support and detach the frame pipe from the inner grooves (A) in the support. While holding the frame on, widen the feet of frame carefully and fully. Adjust the position of the supports according to the distance of front holes in the base of the tool you use. Turn the stand so that the adjusting bolt at its foot or the corporate nameplate faces you. Thicknesser or planer model specified in this manual should be placed so that four holes of the tool base match the largest holes on the support of the stand. 7) Note: When the holes in the tool base do not align with those in the support, unlock the lock plate by raising it, readjust it for fine adjustment and push it down again to lock it. Secure the tool base to the support of the stand with four hex bolts and four nuts provided with the stand. Make sure that these four bolts are inserted from the underside as shown in the figure. [. . . ] All miter saw models specified in this manual should be placed so that two front holes of the tool base match the first front holes on the support. Note: When the holes in the tool base do not align with those in the support, unlock the lock plate by raising it, readjust it for fine adjustment and push it down again to lock it. [. . . ]