User manual MAKITA MS335-4C

[. . . ] 4 C Important: Read this instruction manual carefully before putting the Petrol Brushcutter into operation and strictly observe the safety regulations! English Thank you very much for purchasing the DOLMAR Petrol Brushcutter. We are pleased to recommend to you the DOLMAR Petrol Brushcutter which is the result of a long development programme and many years of knowledge and experience. Please read this booklet which refers in detail to the various points that will demonstrate its outstanding performance. [. . . ] 1 L Note: f the engine is not kept upright, oil may go into around the engine, and may be refilled excessively. I If the oil is filled above the limit, the oil may be contaminated or may catch fire with white smoke. € Remove dust or dirt near the oil refill port, and detach the oil gauge. Otherwise, any sand or dust adhering to the oil gauge may cause irregular oil circulation or wear on the engine parts, which will result in troubles. € As an example to keep the oil gauge clean, it is recommended to insert the oil gauge on its knob side into the engine cover, as shown in Fig. Point 1 in Replacement of oil: “Oil gauge” Upper limit of oil level (Lower part of oil refill port threaded part) Oil gauge Fig. Point 2 in Replacement of oil: “If oil spills out” – oil spills out between the fuel tank and engine main unit, the oil is sucked into through the cooling air intake port, which will If contaminate the engine. 13 REFUELING Handling of fuel It is necessary to handle fuel with utmost care. Refueling must be performed in a sufficiently ventilated room or in the open air. Storage period of fuel Fuel should be used up within a period of 4 weeks, even if it is kept in a special container in a well-ventilated shade. If a special container is not used or if the container is not covered, fuel may deteriorate in one day. STORAGE OF MACHINE AND REFILL TANK – Keep the machine and tank at a cool place free from direct sunshine. Be sure to use an automobile gasoline (regular gasoline or premium gasoline). Points for fuel – Never use a gasoline mixture which contains engine oil. Refueling WARNING: INFLAMMABLES STRICTLY PROHIBITED Gasoline used: Automobile gasoline (unleaded gasoline) – Loosen the tank cap a little so that there will be no difference in atmospheric pressure. € Detach the tank cap, and refuel, discharging air by tilting the fuel tank so that the refuel port will be oriented upward. ) – Wipe well the periphery of the tank cap to prevent foreign matter from entering into the fuel tank. — The tank cap is consumable, and therefore should be renewed every two to three years. Fuel tank cap Fuel upper limit Fuel tank 14 CORRECT HANDLING OF MACHINE Attachment of shoulder strap – Adjust the strap length so that the cutter blade will be kept parallel with the ground. 4 C – In an emergency, push the notches (1) at both sides, and you can detach the machine from you. Do not allow the machine to be deflected toward you or anyone in the work vicinity. WARNING: Failure to maintain complete control of the machine at all could result in serious bodily injury or DEATH. [. . . ] 22 STORAGE WARNING:  hen draining the fuel, be sure to stop the engine and confirm that the engine cools down. W Just after stopping the engine, it may still hot with possibility of burns, inflammability and fire. € Drain up fuel from the fuel tank and carburetor according to the following procedure: 1)  emove the fuel tank cap, and drain fuel completely. R If there is any foreign matter remaining in the fuel tank, remove it completely. [. . . ]