User manual MAKITA PC7314HS

[. . . ] Always follow safety precautions in the Instruction and Safety Manual. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. We are confident that you will be satisfied with this modern piece of equipment. DOLMAR GmbH of Hamburg, Germany is the world’s oldest manufacturer of gasoline-powered chain saws - we got our start in 1927 - giving us very extensive experience with power hand tools. [. . . ] 2 1 Tighten the screw with the combination wrench (1) NOTE: Tighten the screw firmly (30 ± 2 Nm), as otherwise the cutting wheel may slip during cutting. D 12 Tightening the V-belt / Checking V-belt tension IMPORTANT: Exact V-belt tension is essential for maximum cutting performance with minimum fuel consumption. Improper V-belt tension will result in premature wear to the V-belt and V-belt wheel or damage to the clutch bearing. STOP E NOTE: The two fastening nuts (11) must be loosened before tightening the V-belt or checking the tension. To increase the belt tension, turn the tightening screw (12) to the right (clockwise) with the combination wrench included with the Power Cut. The belt tension is correctly adjusted when the nut (13) is centred on the mark (14). 13 IMPORTANT: After tightening/inspection, make certain to tighten the fastening nuts (11) (30 ± 2 Nm). 11 12 14 F Fuels Caution: The Power Cut uses mineral-oil products (gasoline and oil). Do not allow gasoline to come near flames, sparks or fire (explosion hazard). gasoline 100:1 50:1 Fuel mixture The Power Cut is powered by a high-performance two-stroke engine. In case no such fuel is available, you can use fuel with a higher octane value. In order to obtain an optimum engine output and to protect your health and the environment use unleaded fuel only. To lubricate the engine, use a two-stroke engine oil (quality grade TC-3), which is added to the fuel. The engine is designed for the use of DOLMAR HP 100 high-performance two-stroke engine oil at a mixture ratio of only 100:1 to protect the environment. In addition, this ensures a long service life and reliable operation with minimum exhaust emissions. (378 cm3) The correct mixture ratio: 100:1 When using DOLMAR HP 100 high-performance two-stroke engine oil, i. G 13 DOLMAR HP 100 high-performance two-stroke engine oil is available in the following sizes to suit your individual requirements: 0, 5 l Best. 980 008 109 DOLMAR high-performance two-stroke engine oil (50:1) is available in the following sizes to suit your individual requirements: 1 l Best. 980 008 106 NOTE: For preparing the fuel-oil mixture first mix the entire oil quantity with half of the fuel required, then add the remaining fuel. Shake the finished mixture thoroughly before pouring it into the Power Cut tank. Caution: Open the tank cap carefully, as pressure might have built up inside!It is not wise to add more engine oil than specified to ensure safe operation. [. . . ] Please contact your nearest service centre (list enclosed) or the general trading company or importer (see last page), who will gladly provide you with the address of your nearest DOLMAR service centre. Spare parts Reliable long-term operation, as well as the safety of your Power Cut, depend among other things on the quality of the spare parts used. Use only original DOLMAR parts, marked Only original parts are from the same production line as the original unit and therefore ensure the highest possible quality of materials, dimensions, functioning and safety. Only original spare parts and accessories guarantee the highest quality in material, dimensions, functioning and safety. [. . . ]