User manual MAKITA PD491
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual MAKITA PD491. We hope that this MAKITA PD491 user guide will be useful to you.
Manual abstract: user guide MAKITA PD491
Detailed instructions for use are in the User's Guide.
[. . . ] Fit the screws and nuts (see illustration), do not tighten nuts for the moment. C
12 11
13 8 7
Thread cable (7), as shown in picture, through the adapter bracket (8), the compression spring (9), the gas operating device (10) and the Bowden cable sleeve (11). [. . . ] NOTE: Only tighten the clamping screw on the gas lever (12) slightly to prevent the cable slipping out again. The gas lever is set correctly when the power cut is mounted (see “Mounting the power cut”). 9
D
6
11 10
14
15
Mount the clamp bracket (14) from underneath (see circled diagram) against the support plate (17) using screws (16). 16 17
E
Mounting the guide wheel
Push screw (1) through the rectangular hole on the guide trolley (2) (align the sides of the screw with the sides of the hole). mount guide wheel (3) , compression washer (4) , washer (5) and nut (6). Tighten nut (6) so that the guide wheel can be turned on the guide trolley. Fold out (I) the holding brackets (5) and secure (II) using the eccentric plate (6). I 5 6
II
I
7
1
2
4
5
Setting the gas lever
Turn the gas lever (1) back as far as it will go (parallel to the control shaft). 3
2 - 3 mm
Take hold of cable end (3) and pull until the distance between the gas operating device (5) and the gas lever on the power cut (4) is about 2-3 mm. J
3 2
Adjusting the cutting line
If the guide trolley pulls to the left or right of the straight cutting line when you are cutting with the power cut, this can be corrected by pushing aside the support plate (1). Pushing the support plate (1) in the direction A corrects cutting to the left. B 1
Pushing the support plate (1) in the direction B corrects cutting to the right. [. . . ] B 1
Pushing the support plate (1) in the direction B corrects cutting to the right. K
8
A
schematic diagram
Adjusting the wheels
The wheel spacing on the guide trolley may be adjusted if necessary. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE MAKITA PD491
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual MAKITA PD491 will begin.