User manual MAKITA RT0700C

[. . . ] They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. Watch for vibration or wobbling that could indicate improperly installed bit. Always switch off and wait for the bit to come to a complete stop before removing the tool from workpiece. Do not touch the bit immediately after operation; it may be extremely hot and could burn your skin. [. . . ] When you wish to cut grooves more than 3 mm deep, make several passes with progressively deeper bit settings. In this case, firmly clamp a straight board to the workpiece and use it as a guide against the trimmer base. 15) Circular work Circular work may be accomplished if you assemble the straight guide and guide plate as shown in Fig. NOTE: • Circles between 172 mm and 186 mm in radius cannot be cut using this guide. Drive a nail less than 6 mm in diameter into the centre hole to secure the straight guide. 18) Trimmer guide (optional accessory) Trimming, curved cuts in veneers for furniture and the like can be done easily with the trimmer guide. 19) Install the trimmer guide on the tool base with the clamp screw (A). Loosen the clamp screw (B) and adjust the distance between the bit and the trimmer guide by turning the adjusting screw (1 mm per turn). At the desired distance, tighten the clamp screw (B) to secure the trimmer guide in place. 20) When cutting, move the tool with the guide roller riding the side of the workpiece. 21) Templet guide The templet guide provides a sleeve through which the bit passes, allowing use of the trimmer with templet patterns. Place the tool on the templet and move the tool with the templet guide sliding along the side of the templet. 11) NOTE: • The workpiece will be cut a slightly different size from the templet. Allow for the distance (X) between the router bit and the outside of the templet guide. The distance (X) can be calculated by using the following equation: Distance (X) = (outside diameter of the templet guide – router bit diameter) / 2 Tilt base (optional accessory) Tilt base (optional accessory) is convenient for chamfering. 22) Place the tool onto the tilt base and close the locking lever at the desired protrusion of the bit. Firmly clamp a straight board to the workpiece and use it as a guide against the trimmer base. Base protector removed from the tilt base (optional accessory) Mounting the base protector which has been removed from the tilt base on the trimmer base allows the change of the trimmer base from the round base to a square base. For another application, remove the base protector from the tilt base by loosening and removing four screws. Straight guide (Accessory) The straight guide is effectively used for straight cuts when chamfering or grooving. 12) Attach the guide plate to the straight guide with the bolt and the wing nut. Loosen the wing nut on the straight guide and adjust the distance between the bit and the straight guide. [. . . ] Noise The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA): 82 dB (A) Sound power level (LWA): 93 dB (A) Uncertainty (K): 3 dB (A) Wear ear protection ENG900-1 Replacing carbon brushes Vibration The vibration total value (tri-axial vector sum) determined according to EN60745: Work mode : rotation without load Vibration emission (ah) : 2. 5 m/s2 • The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. €¢ The declared vibration emission value may also be used in a preliminary assessment of exposure. WARNING: • The vibration emission during actual use of the power tool can differ from the declared emission value depending on the ways in which the tool is used. [. . . ]