User manual MAKITA UK360D

[. . . ] Grip Battery hood Front carry handle Cultivator blade Transport wheel Rear carry handle Button Red indicator Battery cartridge Indicator lamps CHECK button Battery converter (BCV01) Installation hole Holder Battery port 1 Battery port 2 Rubber cap Product mounting adapter of the BCV01 19. Cord Slit in the lower housing Battery converter (BCV02) Indication lamps Battery lamp 1 Battery lamp 2 Warning lamp Battery selection switch Lock key Main switch Lock-off button Switch lever Drag bar Stopper Deep cultivation - A Middle depth cultivation - B Shallow cultivation - C Transport position - D Handle locking knob 38. Corn spring Tighten Lock pin and snap pin When blade is new When blade is worn Direction of blade rotation Blade facing inward Blade facing outward Left inner blades (outside view) Left outer blades (outside view) Right inner blades (outside view) Right outer blades (outside view) Outside Back view Lock pin Frame SPECIFICATIONS Model Dimensions Blade diameter Tilling width No load speed Net weight Rated voltage Standard battery cartridge and charger Always keep the combinations of battery/ charger on the right columns. 36 V BL3622A DC36WA • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. [. . . ] €¢ When the upper two and lower two indicator lamps light alternately, the battery may have malfunctioned. NOTE: • The indicated capacity may be lower than the actual level during use or immediately after using the tool. €¢ Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. Indication lamp WARNING: • Do not use the battery selection switch during the operation. €¢ After flipping the battery selection switch, the main switch is turned off. 11 & 12) You can switch the battery by flipping the battery selection switch when the tool is equipped two batteries. ) If the tool is equipped one battery, flip the battery button to chose one side which the battery is equipped. €¢ If the tool is equipped one battery and you switch to a battery port in which no battery cartridge is mounted, the indication lamps shows the status No. The warning lamp lights up when a problem occurs, and the tool is automatically switched off about 10 seconds after the warning lamp has lighted. €¢ Lighting-up-red: There are two possibility why the red lamp lights up. ) Turn off the main switch, and restart the tool after the motor cools down. €¢ Blinking red: The blade becomes overloaded by getting stuck because of digging too deep, or clogged up by weeds or stone. To prevent the tool from unintentional starting, a lock-off button is provided. To start the blades’ rotating, depress the lock-off button and then pull the switch lever. The battery cartridge may result in serious personal injury from accidental start-up. €¢ Never start the tool unless it is completely assembled. Operation of the tool in a partially assembled state may result in serious personal injury from accidental start-up. 17) To install the drag bar with stopper, refer to the section titled “Drag bar” in FUNCTIONAL DESCRIPTION. 18) To set the lock key, refer to the section titled “Power switch action” in FUNCTIONAL DESCRIPTION. Assembling and adjusting the angle of the handle CAUTION: • Always perform the adjusting on the flat surface to avoid accidents. €¢ Always be sure that the transport wheel is in the transporting position before you adjust the angle of the handle. €¢ Always hold the handle while adjusting, or the handle may fall on person and cause injuries. [. . . ] Failure to switch off and remove the battery cartridge may result in serious personal injury from accidental start-up. CAUTION: • Always perform on the flat floor to avoid accidents. €¢ Always be sure that the transport wheel is in the transporting position before you bend the handle. €¢ Always hold the handle while loosening the handle locking knob, or the handle may fall on person and cause injuries. [. . . ]